sb/intel/common/spi: Increase flash erase timeout

This patch provides an increased timeout (60ms -> 1s) for SPI
HW-sequencing flash erase operations. Without that the erase for MRC
cache writing on siemens/mc_bdx1 sometimes goes wrong because the
timeout stops waiting for flash cycle completion. It was found
during continuous integration. Investigation showed that the used flash
type takes sporadic (e.g. 5% of the test cycles) more time for completion
of erasing operation if the ambient temperature increases. The measured
time values are in range of data sheet of SPI flash. 60ms is a typical
value. So increasing the value is necessary.

tested on siemens/bdx1; measured time values with increased ambient
temperature of flash were always smaller than worst case value of 1s.

Change-Id: Id50636f9ed834ffd7810946798b300e58b2c14d2
Signed-off-by: Uwe Poeche <uwe.poeche@siemens.com>
Reviewed-on: https://review.coreboot.org/c/coreboot/+/34173
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Werner Zeh <werner.zeh@siemens.com>

0 files changed, 0 insertions, 0 deletions