diff options
| -rw-r--r-- | src/mainboard/asus/kfsn4-dre_k8/Kconfig | 9 | ||||
| -rw-r--r-- | src/mainboard/asus/kfsn4-dre_k8/devicetree.cb | 5 | ||||
| -rw-r--r-- | src/mainboard/asus/kfsn4-dre_k8/get_bus_conf.c | 6 | ||||
| -rw-r--r-- | src/mainboard/asus/kfsn4-dre_k8/romstage.c | 39 |
4 files changed, 35 insertions, 24 deletions
diff --git a/src/mainboard/asus/kfsn4-dre_k8/Kconfig b/src/mainboard/asus/kfsn4-dre_k8/Kconfig index bb05e9569c..39d530bfb0 100644 --- a/src/mainboard/asus/kfsn4-dre_k8/Kconfig +++ b/src/mainboard/asus/kfsn4-dre_k8/Kconfig @@ -9,6 +9,7 @@ config BOARD_SPECIFIC_OPTIONS # dummy select NORTHBRIDGE_AMD_AMDK8 select SOUTHBRIDGE_NVIDIA_CK804 select SUPERIO_WINBOND_W83627THG + select PARALLEL_CPU_INIT select HAVE_HARD_RESET select HAVE_OPTION_TABLE select HAVE_CMOS_DEFAULT @@ -35,15 +36,15 @@ config BOOTBLOCK_MAINBOARD_INIT config DCACHE_RAM_BASE hex - default 0xcf000 + default 0xc8000 config DCACHE_RAM_SIZE hex - default 0x01000 + default 0x08000 config APIC_ID_OFFSET hex - default 0 + default 0x10 config MAINBOARD_PART_NUMBER string @@ -63,7 +64,7 @@ config MAX_PHYSICAL_CPUS config MEM_TRAIN_SEQ int - default 0 + default 1 config HT_CHAIN_UNITID_BASE hex diff --git a/src/mainboard/asus/kfsn4-dre_k8/devicetree.cb b/src/mainboard/asus/kfsn4-dre_k8/devicetree.cb index 0eae37952f..a02b234d04 100644 --- a/src/mainboard/asus/kfsn4-dre_k8/devicetree.cb +++ b/src/mainboard/asus/kfsn4-dre_k8/devicetree.cb @@ -180,11 +180,14 @@ chip northbridge/amd/amdk8/root_complex # Root complex register "sata1_enable" = "1" end end + device pci 18.0 on end # Link 2 == LDT 2 device pci 18.1 on end device pci 18.2 on end device pci 18.3 on end device pci 18.4 on end - device pci 19.0 on end + device pci 19.0 on end # Link 0 == LDT 0 + device pci 19.0 on end # Link 1 == LDT 1 + device pci 19.0 on end # Link 2 == LDT 2 device pci 19.1 on end device pci 19.2 on end device pci 19.3 on end diff --git a/src/mainboard/asus/kfsn4-dre_k8/get_bus_conf.c b/src/mainboard/asus/kfsn4-dre_k8/get_bus_conf.c index 8160457494..d87bc3fcc4 100644 --- a/src/mainboard/asus/kfsn4-dre_k8/get_bus_conf.c +++ b/src/mainboard/asus/kfsn4-dre_k8/get_bus_conf.c @@ -44,9 +44,9 @@ unsigned apicid_ck804; /* Here you only need to set value in pci1234 for HT-IO that could be installed or not You may need to preset pci1234 for HTIO board, please -refer to src/northbridge/amd/amdfam10/get_pci1234.c for detail */ +refer to src/northbridge/amd/amdk8/get_pci1234.c for detail */ static u32 pci1234x[] = { - 0x0000ffc, 0x0000ffc, 0x0000ffc, 0x0000ffc, 0x0000ffc, 0x0000ffc, + 0x0000ff0, 0x0000ff0, 0x0000ff0, }; @@ -54,7 +54,7 @@ static u32 pci1234x[] = { in chain, assume every chain only have 4 ht device at most */ static unsigned hcdnx[] = { - 0x20202020, 0x20202020, 0x20202020, 0x20202020, 0x20202020, 0x20202020, + 0x20202020, 0x20202020, 0x20202020, }; static unsigned get_bus_conf_done = 0; diff --git a/src/mainboard/asus/kfsn4-dre_k8/romstage.c b/src/mainboard/asus/kfsn4-dre_k8/romstage.c index 7098701511..0c701dfc79 100644 --- a/src/mainboard/asus/kfsn4-dre_k8/romstage.c +++ b/src/mainboard/asus/kfsn4-dre_k8/romstage.c @@ -66,6 +66,7 @@ static inline int spd_read_byte(unsigned device, unsigned address) #include <spd.h> #include "cpu/amd/model_fxx/init_cpus.c" #include "cpu/amd/model_fxx/fidvid.c" +#include "northbridge/amd/amdk8/early_ht.c" #define CK804_MB_SETUP \ RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+33, ~(0x0f),(0x04 | 0x01), /* -ENOINFO Proprietary BIOS sets this register; "When in Rome..."*/ @@ -199,7 +200,9 @@ void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx) { struct sys_info *sysinfo = &sysinfo_car; - u32 bsp_apicid = 0, val, wants_reset, needs_reset; + uint32_t bsp_apicid = 0; + uint32_t dword; + uint8_t needs_reset = 0; #if IS_ENABLED(CONFIG_SET_FIDVID) struct cpuid_result cpuid1; #endif @@ -207,8 +210,12 @@ void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx) timestamp_init(timestamp_get()); timestamp_add_now(TS_START_ROMSTAGE); - if (!cpu_init_detectedx && boot_cpu()) + if (!cpu_init_detectedx && boot_cpu()) { + /* Nothing special needs to be done to find bus 0 */ + /* Allow the HT devices to be found */ + enumerate_ht_chain(); sio_setup(); + } post_code(0x30); @@ -226,8 +233,8 @@ void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx) /* Halt if there was a built in self test failure */ report_bist_failure(bist); - val = cpuid_eax(1); - printk(BIOS_DEBUG, "BSP Family_Model: %08x\n", val); + dword = cpuid_eax(1); + printk(BIOS_DEBUG, "BSP Family_Model: %08x\n", dword); printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1); printk(BIOS_DEBUG, "bsp_apicid = %02x\n", bsp_apicid); printk(BIOS_DEBUG, "cpu_init_detectedx = %08lx\n", cpu_init_detectedx); @@ -240,19 +247,21 @@ void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx) setup_coherent_ht_domain(); post_code(0x35); - /* Setup any mainboard PCI settings etc. */ - setup_mb_resource_map(); - post_code(0x36); - /* Wait for all base cores to start */ wait_all_core0_started(); + post_code(0x36); + + /* Setup any mainboard PCI settings etc. */ + setup_mb_resource_map(); + post_code(0x37); if (IS_ENABLED(CONFIG_LOGICAL_CPUS)) { /* Core0 on each node is configured. Now setup any additional cores. */ printk(BIOS_DEBUG, "start_other_cores()\n"); start_other_cores(); - post_code(0x37); + post_code(0x38); wait_all_other_cores_started(bsp_apicid); + post_code(0x39); } ht_setup_chains_x(sysinfo); @@ -280,18 +289,19 @@ void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx) } #endif + init_timer(); /* Need to use TMICT to synchronize FID/VID. */ + printk(BIOS_DEBUG, "set_ck804_base_unit_id()\n"); ck804_control(ctrl_conf_fix_pci_numbering, ARRAY_SIZE(ctrl_conf_fix_pci_numbering), CK804_BOARD_BOOT_BASE_UNIT_UID); - post_code(0x38); - - printk(BIOS_DEBUG, "ck804_early_setup_x()\n"); - wants_reset = ck804_early_setup_x(); + post_code(0x3a); printk(BIOS_DEBUG, "optimize_link_coherent_ht()\n"); needs_reset = optimize_link_coherent_ht(); printk(BIOS_DEBUG, "optimize_link_incoherent_ht()\n"); needs_reset |= optimize_link_incoherent_ht(sysinfo); + printk(BIOS_DEBUG, "ck804_early_setup_x()\n"); + needs_reset |= ck804_early_setup_x(); /* FIDVID change will issue one LDTSTOP and the HT change will be effective too */ if (needs_reset) { @@ -299,9 +309,6 @@ void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx) soft_reset(); } - if (wants_reset) - printk(BIOS_DEBUG, "ck804_early_setup_x wanted additional reset!\n"); - post_code(0x3b); allow_all_aps_stop(bsp_apicid); |