diff options
| -rw-r--r-- | src/mainboard/google/reef/variants/pyro/devicetree.cb | 19 |
1 files changed, 11 insertions, 8 deletions
diff --git a/src/mainboard/google/reef/variants/pyro/devicetree.cb b/src/mainboard/google/reef/variants/pyro/devicetree.cb index 41086f024e..72ad57c567 100644 --- a/src/mainboard/google/reef/variants/pyro/devicetree.cb +++ b/src/mainboard/google/reef/variants/pyro/devicetree.cb @@ -187,6 +187,12 @@ chip soc/intel/apollolake .cid = PNP0C50_CID, .desc = WCOM_TS_DESC, .irq = IRQ_LEVEL_LOW(GPIO_21_IRQ), + .reset_gpio = ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_36), + .reset_delay_ms = 20, + .enable_gpio = ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_152), + .enable_delay_ms = 1, + .has_power_resource = 1, + .disable_gpio_export_in_crs = 1, }" register "hid_desc_reg_offset" = "0x1" device i2c 0xA on end @@ -196,14 +202,11 @@ chip soc/intel/apollolake register "desc" = ""ELAN Touchscreen"" register "irq" = "IRQ_EDGE_LOW(GPIO_21_IRQ)" register "probed" = "1" - - chip drivers/generic/gpio_regulator - register "name" = ""vcc33"" - register "gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_152)" - register "enabled_on_boot" = "1" - device generic 0 on end - end - + register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_36)" + register "reset_delay_ms" = "20" + register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_152)" + register "enable_delay_ms" = "1" + register "has_power_resource" = "1" device i2c 10 on end end end # - I2C 3 |