diff options
Diffstat (limited to 'src/drivers/parade/ps8625/ps8625.c')
| -rw-r--r-- | src/drivers/parade/ps8625/ps8625.c | 134 |
1 files changed, 5 insertions, 129 deletions
diff --git a/src/drivers/parade/ps8625/ps8625.c b/src/drivers/parade/ps8625/ps8625.c index 6cbe3b71d6..05219b0333 100644 --- a/src/drivers/parade/ps8625/ps8625.c +++ b/src/drivers/parade/ps8625/ps8625.c @@ -17,143 +17,19 @@ * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA */ -#include "ps8625.h" - #include <device/i2c.h> #include <stdint.h> #include <stdlib.h> -struct parade_write { - uint8_t offset; - uint8_t reg; - uint8_t val; -}; - -static const struct parade_write parade_writes[] = { - { 0x02, 0xa1, 0x01 }, /* HPD low */ - /* - * SW setting - * [1:0] SW output 1.2V voltage is lower to 96% - */ - { 0x04, 0x14, 0x01 }, - /* - * RCO SS setting - * [5:4] = b01 0.5%, b10 1%, b11 1.5% - */ - { 0x04, 0xe3, 0x20 }, - { 0x04, 0xe2, 0x80 }, /* [7] RCO SS enable */ - /* - * RPHY Setting - * [3:2] CDR tune wait cycle before - * measure for fine tune b00: 1us, - * 01: 0.5us, 10:2us, 11:4us. - */ - { 0x04, 0x8a, 0x0c }, - { 0x04, 0x89, 0x08 }, /* [3] RFD always on */ - /* - * CTN lock in/out: - * 20000ppm/80000ppm. Lock out 2 - * times. - */ - { 0x04, 0x71, 0x2d }, - /* - * 2.7G CDR settings - * NOF=40LSB for HBR CDR setting - */ - { 0x04, 0x7d, 0x07 }, - { 0x04, 0x7b, 0x00 }, /* [1:0] Fmin=+4bands */ - { 0x04, 0x7a, 0xfd }, /* [7:5] DCO_FTRNG=+-40% */ - /* - * 1.62G CDR settings - * [5:2]NOF=64LSB [1:0]DCO scale is 2/5 - */ - { 0x04, 0xc0, 0x12 }, - { 0x04, 0xc1, 0x92 }, /* Gitune=-37% */ - { 0x04, 0xc2, 0x1c }, /* Fbstep=100% */ - { 0x04, 0x32, 0x80 }, /* [7] LOS signal disable */ - /* - * RPIO Setting - * [7:4] LVDS driver bias current : - * 75% (250mV swing) - */ - { 0x04, 0x00, 0xb0 }, - /* - * [7:6] Right-bar GPIO output strength is 8mA - */ - { 0x04, 0x15, 0x40 }, - /* EQ Training State Machine Setting */ - { 0x04, 0x54, 0x10 }, /* RCO calibration start */ - /* [4:0] MAX_LANE_COUNT set to one lane */ - { 0x01, 0x02, 0x81 }, - /* [4:0] LANE_COUNT_SET set to one lane */ - { 0x01, 0x21, 0x81 }, - { 0x00, 0x52, 0x20 }, - { 0x00, 0xf1, 0x03 }, /* HPD CP toggle enable */ - { 0x00, 0x62, 0x41 }, - /* Counter number, add 1ms counter delay */ - { 0x00, 0xf6, 0x01 }, - /* - * [6]PWM function control by - * DPCD0040f[7], default is PWM - * block always works. - */ - { 0x00, 0x77, 0x06 }, - /* - * 04h Adjust VTotal tolerance to - * fix the 30Hz no display issue - */ - { 0x00, 0x4c, 0x04 }, - /* DPCD00400='h00, Parade OUI = 'h001cf8 */ - { 0x01, 0xc0, 0x00 }, - { 0x01, 0xc1, 0x1c }, /* DPCD00401='h1c */ - { 0x01, 0xc2, 0xf8 }, /* DPCD00402='hf8 */ - /* - * DPCD403~408 = ASCII code - * D2SLV5='h4432534c5635 - */ - { 0x01, 0xc3, 0x44 }, - { 0x01, 0xc4, 0x32 }, /* DPCD404 */ - { 0x01, 0xc5, 0x53 }, /* DPCD405 */ - { 0x01, 0xc6, 0x4c }, /* DPCD406 */ - { 0x01, 0xc7, 0x56 }, /* DPCD407 */ - { 0x01, 0xc8, 0x35 }, /* DPCD408 */ - /* - * DPCD40A, Initial Code major revision - * '01' - */ - { 0x01, 0xca, 0x01 }, - /* DPCD40B, Initial Code minor revision '05' */ - { 0x01, 0xcb, 0x05 }, - /* DPCD720, Select internal PWM */ - { 0x01, 0xa5, 0xa0 }, - /* - * FFh for 100% PWM of brightness, 0h for 0% - * brightness - */ - { 0x01, 0xa7, 0xff }, - /* - * Set LVDS output as 6bit-VESA mapping, - * single LVDS channel - */ - { 0x01, 0xcc, 0x13 }, - /* Enable SSC set by register */ - { 0x02, 0xb1, 0x20 }, - /* - * Set SSC enabled and +/-1% central - * spreading - */ - { 0x04, 0x10, 0x16 }, - /* MPU Clock source: LC => RCO */ - { 0x04, 0x59, 0x60 }, - { 0x04, 0x54, 0x14 }, /* LC -> RCO */ - { 0x02, 0xa1, 0x91 } /* HPD high */ -}; +#include "ps8625.h" -void parade_ps8625_bridge_setup(unsigned bus, unsigned chip_base) +void parade_ps8625_bridge_setup(unsigned bus, unsigned chip_base, + const struct parade_write *parade_writes, + int parade_write_count) { int i; - for (i = 0; i < ARRAY_SIZE(parade_writes); i++) { + for (i = 0; i < parade_write_count; i++) { const struct parade_write *w = ¶de_writes[i]; i2c_write(bus, chip_base + w->offset, w->reg, sizeof(w->reg), &w->val, sizeof(w->val)); |