diff options
Diffstat (limited to 'src/mainboard/lenovo/t520/variants/w520/devicetree.cb')
| -rw-r--r-- | src/mainboard/lenovo/t520/variants/w520/devicetree.cb | 168 |
1 files changed, 168 insertions, 0 deletions
diff --git a/src/mainboard/lenovo/t520/variants/w520/devicetree.cb b/src/mainboard/lenovo/t520/variants/w520/devicetree.cb new file mode 100644 index 0000000000..b69b66c2fa --- /dev/null +++ b/src/mainboard/lenovo/t520/variants/w520/devicetree.cb @@ -0,0 +1,168 @@ +chip northbridge/intel/sandybridge + # IGD Displays + register "gfx.ndid" = "3" + register "gfx.did" = "{ 0x80000100, 0x80000240, 0x80000410, 0x80000410, 0x00000005 }" + + # Enable DisplayPort Hotplug with 6ms pulse + register "gpu_dp_d_hotplug" = "0x06" + + # Enable Panel as LVDS and configure power delays + register "gpu_panel_port_select" = "0" # LVDS + register "gpu_panel_power_cycle_delay" = "5" + register "gpu_panel_power_up_delay" = "300" # T1+T2: 30ms + register "gpu_panel_power_down_delay" = "300" # T5+T6: 30ms + register "gpu_panel_power_backlight_on_delay" = "2000" # T3: 200ms + register "gpu_panel_power_backlight_off_delay" = "2000" # T4: 200ms + register "gfx.use_spread_spectrum_clock" = "1" + register "gfx.link_frequency_270_mhz" = "1" + register "gpu_cpu_backlight" = "0x1155" + register "gpu_pch_backlight" = "0x06100610" + + device cpu_cluster 0 on + chip cpu/intel/socket_rPGA988B + device lapic 0 on end + end + chip cpu/intel/model_206ax + # Magic APIC ID to locate this chip + device lapic 0xACAC off end + + register "c1_acpower" = "1" # ACPI(C1) = MWAIT(C1) + register "c2_acpower" = "3" # ACPI(C2) = MWAIT(C3) + register "c3_acpower" = "5" # ACPI(C3) = MWAIT(C7) + + register "c1_battery" = "1" # ACPI(C1) = MWAIT(C1) + register "c2_battery" = "3" # ACPI(C2) = MWAIT(C3) + register "c3_battery" = "5" # ACPI(C3) = MWAIT(C7) + end + end + + register "pci_mmio_size" = "2048" + + device domain 0 on + device pci 00.0 on end # host bridge + device pci 01.0 on end # NVIDIA Corporation GF119M [NVS 4200M] + device pci 02.0 on end # vga controller + + chip southbridge/intel/bd82x6x # Intel Series 6 Cougar Point PCH + # GPI routing + # 0 No effect (default) + # 1 SMI# (if corresponding ALT_GPI_SMI_EN bit is also set) + # 2 SCI (if corresponding GPIO_EN bit is also set) + register "alt_gp_smi_en" = "0x0000" + register "gpi1_routing" = "2" + register "gpi13_routing" = "2" + + # Enable SATA ports 0 (HDD bay) & 1 (ODD bay) & 2 (mSATA) & 3 (eSATA) & 4 (dock) + register "sata_port_map" = "0x1f" + # Set max SATA speed to 6.0 Gb/s + register "sata_interface_speed_support" = "0x3" + + register "gen1_dec" = "0x7c1601" + register "gen2_dec" = "0x0c15e1" + register "gen4_dec" = "0x0c06a1" + + # Enable zero-based linear PCIe root port functions + register "pcie_port_coalesce" = "1" + + register "c2_latency" = "101" # c2 not supported + register "p_cnt_throttling_supported" = "1" + + register "pcie_hotplug_map" = "{ 0, 0, 0, 1, 0, 0, 0, 0 }" + + register "spi_uvscc" = "0x2005" + register "spi_lvscc" = "0x2005" + + device pci 16.0 on end # Management Engine Interface 1 + device pci 16.1 off end + device pci 16.2 off end + device pci 16.3 off end + device pci 19.0 on end # Intel Gigabit Ethernet + device pci 1a.0 on end # USB2 EHCI #2 + device pci 1b.0 on end # High Definition Audio + device pci 1c.0 off end # PCIe Port #1 + device pci 1c.1 on end # PCIe Port #2 Integrated Wireless LAN + device pci 1c.2 off end # PCIe Port #3 + device pci 1c.3 on end # PCIe Port #4 Express Card + device pci 1c.4 on end # PCIe Port #5 MMC/SDXC + IEEE1394 + device pci 1c.5 off end # PCIe Port #6 Intel Ethernet PHY + device pci 1c.6 on end # PCIe Port #7 USB 3.0 only W520 + device pci 1c.7 off end # PCIe Port #8 + device pci 1d.0 on end # USB2 EHCI #1 + device pci 1f.0 on #LPC bridge + chip ec/lenovo/pmh7 + device pnp ff.1 on # dummy + end + register "backlight_enable" = "0x01" + register "dock_event_enable" = "0x01" + end + + chip drivers/pc80/tpm + device pnp 0c31.0 on end + end + + chip ec/lenovo/h8 + device pnp ff.2 on # dummy + io 0x60 = 0x62 + io 0x62 = 0x66 + io 0x64 = 0x1600 + io 0x66 = 0x1604 + end + + register "config0" = "0xa7" + register "config1" = "0x09" + register "config2" = "0xa0" + register "config3" = "0xc2" + + register "beepmask0" = "0x00" + register "beepmask1" = "0x86" + register "has_power_management_beeps" = "0" + register "event2_enable" = "0xff" + register "event3_enable" = "0xff" + register "event4_enable" = "0xd0" + register "event5_enable" = "0xfc" + register "event6_enable" = "0x00" + register "event7_enable" = "0x01" + register "event8_enable" = "0x7b" + register "event9_enable" = "0xff" + register "eventa_enable" = "0x01" + register "eventb_enable" = "0x00" + register "eventc_enable" = "0xff" + register "eventd_enable" = "0xff" + register "evente_enable" = "0x0d" + + register "has_bdc_detection" = "1" + register "bdc_gpio_num" = "54" + register "bdc_gpio_lvl" = "0" + end + chip drivers/lenovo/hybrid_graphics + device pnp ff.f on end # dummy + + register "detect_gpio" = "21" + + register "has_panel_hybrid_gpio" = "1" + register "panel_hybrid_gpio" = "52" + register "panel_integrated_lvl" = "1" + + register "has_backlight_gpio" = "0" + register "has_dgpu_power_gpio" = "0" + + register "has_thinker1" = "1" + end + end # LPC bridge + device pci 1f.2 on end # SATA Controller 1 + device pci 1f.3 on # SMBUS controller + # eeprom, 8 virtual devices, same chip + chip drivers/i2c/at24rf08c + device i2c 54 on end + device i2c 55 on end + device i2c 56 on end + device i2c 57 on end + device i2c 5c on end + device i2c 5d on end + device i2c 5e on end + device i2c 5f on end + end + end # SMBus + end + end +end |