summaryrefslogtreecommitdiff
path: root/src/mainboard/lippert/frontrunner-af/mainboard.c
diff options
context:
space:
mode:
Diffstat (limited to 'src/mainboard/lippert/frontrunner-af/mainboard.c')
-rw-r--r--src/mainboard/lippert/frontrunner-af/mainboard.c68
1 files changed, 39 insertions, 29 deletions
diff --git a/src/mainboard/lippert/frontrunner-af/mainboard.c b/src/mainboard/lippert/frontrunner-af/mainboard.c
index 6ad5234d81..9e3eab7a6c 100644
--- a/src/mainboard/lippert/frontrunner-af/mainboard.c
+++ b/src/mainboard/lippert/frontrunner-af/mainboard.c
@@ -59,32 +59,41 @@ static const u16 sio_init_table[] = { // hi = offset, lo = value
static void init(struct device *dev)
{
- volatile u8 *spi_base; // base addr of Hudson's SPI host controller
+ volatile u8 *spi_base; /* base addr of Hudson's SPI host controller */
int i;
printk(BIOS_DEBUG, CONFIG_MAINBOARD_PART_NUMBER " ENTER %s\n", __func__);
/* Init Hudson GPIOs. */
printk(BIOS_DEBUG, "Init FCH GPIOs @ 0x%08x\n", ACPI_MMIO_BASE+GPIO_BASE);
- FCH_IOMUX(50) = 2; // GPIO50: FCH_ARST#_GATE resets stuck PCIe devices
- FCH_GPIO (50) = 0xC0; // = output set to 1 as it's never needed
- FCH_IOMUX(197) = 2; // GPIO197: BIOS_DEFAULTS# = input (int. PU)
- FCH_IOMUX(56) = 1; // GPIO58-56: REV_ID2-0
- FCH_GPIO (56) = 0x28; // = inputs, disable int. pull-ups
- FCH_IOMUX(57) = 1;
- FCH_GPIO (57) = 0x28;
- FCH_IOMUX(58) = 1;
- FCH_GPIO (58) = 0x28;
- FCH_IOMUX(96) = 1; // "Gpio96": GEVENT0# signal on X2 connector (int. PU)
- FCH_IOMUX(52) = 1; // GPIO52,61,62,187-192 free to use on X2 connector
- FCH_IOMUX(61) = 2; // default to inputs with int. PU
- FCH_IOMUX(62) = 2;
- FCH_IOMUX(187) = 2;
- FCH_IOMUX(188) = 2;
- FCH_IOMUX(189) = 1;
- FCH_IOMUX(190) = 1;
- FCH_IOMUX(191) = 1;
- FCH_IOMUX(192) = 1;
- if (!fch_gpio_state(197)) // just in case anyone cares
+ /* GPIO50: FCH_ARST#_GATE resets stuck PCIe devices */
+ iomux_write8(50, 2);
+ /* output set to 1 as it's never needed */
+ iomux_write8(50, 0xc0);
+ /* GPIO197: BIOS_DEFAULTS# = input (int. PU) */
+ iomux_write8(197, 2);
+ /* GPIO58-56: REV_ID2-0 */
+ iomux_write8(56, 1);
+ /* inputs, disable int. pull-ups */
+ gpio_100_write8(56, 0x28);
+ iomux_write8(57, 1);
+ gpio_100_write8(57, 0x28);
+ iomux_write8(58, 1);
+ gpio_100_write8(58, 0x28);
+ /* "Gpio96": GEVENT0# signal on X2 connector (int. PU) */
+ iomux_write8(96, 1);
+ /* GPIO52,61,62,187-192 free to use on X2 connector */
+ iomux_write8(52, 1);
+ /* default to inputs with int. PU */
+ iomux_write8(61, 2);
+ iomux_write8(62, 2);
+ iomux_write8(187, 2);
+ iomux_write8(188, 2);
+ iomux_write8(189, 1);
+ iomux_write8(190, 1);
+ iomux_write8(191, 1);
+ iomux_write8(192, 1);
+ /* just in case anyone cares */
+ if (!fch_gpio_state(197))
printk(BIOS_INFO, "BIOS_DEFAULTS jumper is present.\n");
printk(BIOS_INFO, "Board revision ID: %u\n",
fch_gpio_state(58)<<2 | fch_gpio_state(57)<<1 | fch_gpio_state(56));
@@ -99,9 +108,11 @@ static void init(struct device *dev)
/* Lower SPI speed from default 66 to 22 MHz for SST 25VF032B */
spi_base = (u8 *)((uintptr_t)pci_read_config32(pcidev_on_root(0x14, 3),
0xA0) & 0xFFFFFFE0);
- spi_base[0x0D] = (spi_base[0x0D] & ~0x30) | 0x20; // NormSpeed in SPI_Cntrl1 register
+ /* NormSpeed in SPI_Cntrl1 register */
+ spi_base[0x0D] = (spi_base[0x0D] & ~0x30) | 0x20;
- /* Notify the SMC we're alive and kicking, or after a while it will
+ /*
+ * Notify the SMC we're alive and kicking, or after a while it will
* effect a power cycle and switch to the alternate BIOS chip.
* Should be done as late as possible.
* Failure here does not matter if watchdog was already disabled,
@@ -122,12 +133,11 @@ static void mainboard_enable(struct device *dev)
/* enable GPP CLK0 */
/* disable GPP CLK1 thru SLT_GFX_CLK */
- u8 *misc_mem_clk_cntrl = (u8 *)(ACPI_MMIO_BASE + MISC_BASE);
- write8(misc_mem_clk_cntrl + 0, 0x0F);
- write8(misc_mem_clk_cntrl + 1, 0x00);
- write8(misc_mem_clk_cntrl + 2, 0x00);
- write8(misc_mem_clk_cntrl + 3, 0x00);
- write8(misc_mem_clk_cntrl + 4, 0x00);
+ misc_write8(0, 0x0f);
+ misc_write8(1, 0);
+ misc_write8(2, 0);
+ misc_write8(3, 0);
+ misc_write8(4, 0);
/*
* Initialize ASF registers to an arbitrary address because someone