diff options
Diffstat (limited to 'src/mainboard/lippert/hurricane-lx/romstage.c')
-rw-r--r-- | src/mainboard/lippert/hurricane-lx/romstage.c | 175 |
1 files changed, 175 insertions, 0 deletions
diff --git a/src/mainboard/lippert/hurricane-lx/romstage.c b/src/mainboard/lippert/hurricane-lx/romstage.c new file mode 100644 index 0000000000..92f0f0f6f1 --- /dev/null +++ b/src/mainboard/lippert/hurricane-lx/romstage.c @@ -0,0 +1,175 @@ +/* + * This file is part of the coreboot project. + * + * Copyright (C) 2007 Advanced Micro Devices, Inc. + * Copyright (C) 2010 LiPPERT Embedded Computers GmbH + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License as published by + * the Free Software Foundation; either version 2 of the License, or + * (at your option) any later version. + * + * This program is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the + * GNU General Public License for more details. + * + * You should have received a copy of the GNU General Public License + * along with this program; if not, write to the Free Software + * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA + */ + +/* Based on romstage.c from the SpaceRunner-LX mainboard. */ + +#include <stdlib.h> +#include <stdint.h> +#include <device/pci_def.h> +#include <arch/io.h> +#include <device/pnp_def.h> +#include <arch/hlt.h> +#include <console/console.h> +#include "lib/ramtest.c" +#include "cpu/x86/bist.h" +#include "cpu/x86/msr.h" +#include <cpu/amd/lxdef.h> +#include <cpu/amd/geode_post_code.h> +#include "southbridge/amd/cs5536/cs5536.h" + +#include "southbridge/amd/cs5536/cs5536_early_smbus.c" +#include "southbridge/amd/cs5536/cs5536_early_setup.c" +#include "superio/ite/it8712f/it8712f_early_serial.c" + +/* Bit0 enables Spread Spectrum. */ +#define SMC_CONFIG 0x01 + +#define ManualConf 1 /* No automatic strapped PLL config */ +#define PLLMSRhi 0x0000049C /* Manual settings for the PLL */ +#define PLLMSRlo 0x00DE6001 +#define DIMM0 0xA0 +#define DIMM1 0xA2 + +static inline int spd_read_byte(unsigned int device, unsigned int address) +{ + if (device != DIMM0) + return 0xFF; /* No DIMM1, don't even try. */ + + return smbus_read_byte(device, address); +} + +#if !CONFIG_BOARD_OLD_REVISION +/* Send config data to System Management Controller via SMB. */ +static int smc_send_config(unsigned char config_data) +{ + if (smbus_check_stop_condition(SMBUS_IO_BASE)) + return 1; + if (smbus_start_condition(SMBUS_IO_BASE)) + return 2; + if (smbus_send_slave_address(SMBUS_IO_BASE, 0x50)) // SMC address + return 3; + if (smbus_send_command(SMBUS_IO_BASE, 0x28)) // set config data + return 4; + if (smbus_send_command(SMBUS_IO_BASE, 0x01)) // data length + return 5; + if (smbus_send_command(SMBUS_IO_BASE, config_data)) + return 6; + smbus_stop_condition(SMBUS_IO_BASE); + return 0; +} +#endif + +#include "northbridge/amd/lx/raminit.h" +#include "northbridge/amd/lx/pll_reset.c" +#include "northbridge/amd/lx/raminit.c" +#include "lib/generic_sdram.c" +#include "cpu/amd/model_lx/cpureginit.c" +#include "cpu/amd/model_lx/syspreinit.c" +#include "cpu/amd/model_lx/msrinit.c" + +static const u16 sio_init_table[] = { // hi=data, lo=index + 0x0707, // select LDN 7 (GPIO, SPI, watchdog, ...) + 0x042C, // disable ATXPG; VIN6 enabled, FAN4/5 disabled, VIN7,VIN3 enabled + 0x1423, // don't delay PoWeROK1/2 + 0x9072, // watchdog triggers PWROK, counts seconds +#if !CONFIG_USE_WATCHDOG_ON_BOOT + 0x0073, 0x0074, // disarm watchdog by changing 56 s timeout to 0 +#endif + 0xBF25, 0x172A, 0xF326, // select GPIO function for most pins + 0xBF27, 0xFF28, 0x2D29, // (GP36=FAN_CTL3 (PWM), GP23,22,16,15=SPI, GP13=PWROK1) + 0x66B8, 0x0CB9, // enable pullups on SPI, RS485_EN + 0x07C0, // enable Simple-I/O for GP12-10= RS485_EN2,1, WD_ACTIVE + 0x06C8, // config GP12,11 as output, GP10 as input + 0x2DF5, // map Hw Monitor Thermal Output to GP55 +#if CONFIG_BOARD_OLD_REVISION + 0x1F2A, 0xC072, // switch GP13 to GPIO, WDT output from PWROK to KRST +#endif +}; + +/* Early mainboard specific GPIO setup. */ +static void mb_gpio_init(void) +{ + int i; + + /* Init Super I/O WDT, GPIOs. Done early, WDT init may trigger reset! */ + it8712f_enter_conf(); + for (i = 0; i < ARRAY_SIZE(sio_init_table); i++) { + u16 val = sio_init_table[i]; + outb((u8)val, SIO_INDEX); + outb(val >> 8, SIO_DATA); + } + it8712f_exit_conf(); +} + +void main(unsigned long bist) +{ + post_code(0x01); + + static const struct mem_controller memctrl[] = { + {.channel0 = {(0xa << 3) | 0, (0xa << 3) | 1}} + }; + + SystemPreInit(); + msr_init(); + + cs5536_early_setup(); + + /* + * Note: Must do this AFTER the early_setup! It is counting on some + * early MSR setup for CS5536. + */ + it8712f_enable_serial(0, CONFIG_TTYS0_BASE); // Does not use its 1st parameter + mb_gpio_init(); + uart_init(); + console_init(); + + /* Halt if there was a built in self test failure */ + report_bist_failure(bist); + + pll_reset(ManualConf); + + cpuRegInit(0, DIMM0, DIMM1, DRAM_TERMINATED); + +#if CONFIG_BOARD_OLD_REVISION + /* + * Old revision boards need a jumper shorting the power button to power + * on automatically. So we must disable the button's fail-safe function, + * or the board will shut down after 4 s. + */ + outl(0, PMS_IO_BASE + PM_FSD); // Fail-Save Delay register +#else + int err; + /* bit0 = Spread Spectrum */ + if ((err = smc_send_config(SMC_CONFIG))) { + print_err("ERROR "); + print_err_char('0'+err); + print_err(" sending config data to SMC\n"); + } +#endif + + sdram_initialize(1, memctrl); + + /* Check memory. */ + /* ram_check(0, 640 * 1024); */ + + /* Memory is setup. Return to cache_as_ram.inc and continue to boot. */ + return; +} |