diff options
Diffstat (limited to 'src/mainboard/msi/ms7260/Options.lb')
| -rw-r--r-- | src/mainboard/msi/ms7260/Options.lb | 192 |
1 files changed, 192 insertions, 0 deletions
diff --git a/src/mainboard/msi/ms7260/Options.lb b/src/mainboard/msi/ms7260/Options.lb new file mode 100644 index 0000000000..1b317e7143 --- /dev/null +++ b/src/mainboard/msi/ms7260/Options.lb @@ -0,0 +1,192 @@ +## +## This file is part of the LinuxBIOS project. +## +## Copyright (C) 2007 Uwe Hermann <uwe@hermann-uwe.de> +## +## This program is free software; you can redistribute it and/or modify +## it under the terms of the GNU General Public License as published by +## the Free Software Foundation; either version 2 of the License, or +## (at your option) any later version. +## +## This program is distributed in the hope that it will be useful, +## but WITHOUT ANY WARRANTY; without even the implied warranty of +## MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the +## GNU General Public License for more details. +## +## You should have received a copy of the GNU General Public License +## along with this program; if not, write to the Free Software +## Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA +## + +uses HAVE_MP_TABLE +uses HAVE_PIRQ_TABLE +uses USE_FALLBACK_IMAGE +uses USE_FAILOVER_IMAGE +uses HAVE_FALLBACK_BOOT +uses HAVE_FAILOVER_BOOT +uses HAVE_HARD_RESET +uses IRQ_SLOT_COUNT +uses HAVE_OPTION_TABLE +uses CONFIG_MAX_CPUS +uses CONFIG_MAX_PHYSICAL_CPUS +uses CONFIG_LOGICAL_CPUS +uses CONFIG_IOAPIC +uses CONFIG_SMP +uses FALLBACK_SIZE +uses FAILOVER_SIZE +uses ROM_SIZE +uses ROM_SECTION_SIZE +uses ROM_IMAGE_SIZE +uses ROM_SECTION_SIZE +uses ROM_SECTION_OFFSET +uses CONFIG_ROM_PAYLOAD +uses CONFIG_ROM_PAYLOAD_START +uses CONFIG_COMPRESSED_PAYLOAD_NRV2B +uses CONFIG_COMPRESSED_PAYLOAD_LZMA +uses CONFIG_PRECOMPRESSED_PAYLOAD +uses PAYLOAD_SIZE +uses _ROMBASE +uses XIP_ROM_SIZE +uses XIP_ROM_BASE +uses STACK_SIZE +uses HEAP_SIZE +uses USE_OPTION_TABLE +uses LB_CKS_RANGE_START +uses LB_CKS_RANGE_END +uses LB_CKS_LOC +uses MAINBOARD_PART_NUMBER +uses MAINBOARD_VENDOR +uses MAINBOARD +uses MAINBOARD_PCI_SUBSYSTEM_VENDOR_ID +uses MAINBOARD_PCI_SUBSYSTEM_DEVICE_ID +uses LINUXBIOS_EXTRA_VERSION +uses _RAMBASE +uses TTYS0_BAUD +uses TTYS0_BASE +uses TTYS0_LCS +uses DEFAULT_CONSOLE_LOGLEVEL +uses MAXIMUM_CONSOLE_LOGLEVEL +uses MAINBOARD_POWER_ON_AFTER_POWER_FAIL +uses CONFIG_CONSOLE_SERIAL8250 +uses HAVE_INIT_TIMER # ? +uses CROSS_COMPILE +uses CC +uses HOSTCC +uses OBJCOPY +uses CONFIG_CHIP_NAME +uses CONFIG_CONSOLE_VGA +uses CONFIG_PCI_ROM_RUN +uses CONFIG_USBDEBUG_DIRECT +uses HW_MEM_HOLE_SIZEK +uses HW_MEM_HOLE_SIZE_AUTO_INC +uses K8_HT_FREQ_1G_SUPPORT +uses HT_CHAIN_UNITID_BASE +uses HT_CHAIN_END_UNITID_BASE +uses SB_HT_CHAIN_ON_BUS0 +uses SB_HT_CHAIN_UNITID_OFFSET_ONLY +uses USE_DCACHE_RAM +uses DCACHE_RAM_BASE +uses DCACHE_RAM_SIZE +uses DCACHE_RAM_GLOBAL_VAR_SIZE +uses CONFIG_USE_INIT +uses SERIAL_CPU_INIT +uses ENABLE_APIC_EXT_ID +uses APIC_ID_OFFSET +uses LIFT_BSP_APIC_ID +uses CONFIG_PCI_64BIT_PREF_MEM +uses CONFIG_LB_MEM_TOPK +uses CONFIG_AP_CODE_IN_CAR +uses MEM_TRAIN_SEQ +uses WAIT_BEFORE_CPUS_INIT +uses CONFIG_USE_PRINTK_IN_CAR + +default ROM_SIZE = 512 * 1024 +default FALLBACK_SIZE = (256 * 1024) - (4 * 1024) +default FAILOVER_SIZE = 4 * 1024 +default CONFIG_LB_MEM_TOPK = 2048 # 1MB more for pgtbl. +default HAVE_FALLBACK_BOOT = 1 +default HAVE_FAILOVER_BOOT = 1 +default HAVE_HARD_RESET = 1 +default HAVE_PIRQ_TABLE = 1 +default IRQ_SLOT_COUNT = 11 # TODO: Check if correct. +default HAVE_MP_TABLE = 1 # TODO: Check if correct. +default HAVE_OPTION_TABLE = 1 +default CONFIG_SMP = 1 +default CONFIG_MAX_CPUS = 2 +default CONFIG_MAX_PHYSICAL_CPUS = 1 +default CONFIG_LOGICAL_CPUS = 1 +# default SERIAL_CPU_INIT = 0 +default ENABLE_APIC_EXT_ID = 0 +default APIC_ID_OFFSET = 0x10 +default LIFT_BSP_APIC_ID = 1 +default CONFIG_CHIP_NAME = 1 + +# Move the default LinuxBIOS CMOS range off of AMD RTC registers. +default LB_CKS_RANGE_START = 49 +default LB_CKS_RANGE_END = 122 +default LB_CKS_LOC = 123 + +# Memory hole size. 0 means disable, others will enable the hole. In that +# case, if it is smaller than mmio_basek, it will use mmio_basek instead. +# default HW_MEM_HOLE_SIZEK = 0x200000 # 2GB +default HW_MEM_HOLE_SIZEK = 0x100000 # 1GB +# default HW_MEM_HOLE_SIZEK = 0x80000 # 512MB + +# Make auto increase hole size to avoid hole_startk equal to basek so as +# to make some kernel happy. +# default HW_MEM_HOLE_SIZE_AUTO_INC = 1 + +# Opteron K8 1G HT support. +default K8_HT_FREQ_1G_SUPPORT = 1 + +# HT Unit ID offset, default is 1, the typical one, 0 means only one HT device. +default HT_CHAIN_UNITID_BASE = 0 + +# Real SB Unit ID, default is 0x20, mean don't touch it at last. +# default HT_CHAIN_END_UNITID_BASE = 0x6 + +# Make the SB HT chain on bus 0, default is not (0). +default SB_HT_CHAIN_ON_BUS0 = 2 + +# Only offset for SB chain? Default is yes (1). +default SB_HT_CHAIN_UNITID_OFFSET_ONLY = 0 + +# Allow capable device use that above 4GB. +# default CONFIG_PCI_64BIT_PREF_MEM = 1 + +default CONFIG_CONSOLE_VGA = 1 # Needed for VGA. +default CONFIG_PCI_ROM_RUN = 1 # Needed for VGA. +default CONFIG_USBDEBUG_DIRECT = 0 +default USE_DCACHE_RAM = 1 +default DCACHE_RAM_BASE = 0xc8000 +default DCACHE_RAM_SIZE = 0x08000 +default DCACHE_RAM_GLOBAL_VAR_SIZE = 0x01000 +default CONFIG_USE_INIT = 0 +default CONFIG_AP_CODE_IN_CAR = 0 +default MEM_TRAIN_SEQ = 2 +default WAIT_BEFORE_CPUS_INIT = 0 +default CONFIG_IOAPIC = 1 +default MAINBOARD_PART_NUMBER = "K9N Neo (MS-7260)" +default MAINBOARD_VENDOR = "MSI" +default MAINBOARD_PCI_SUBSYSTEM_VENDOR_ID = 0x1462 +default MAINBOARD_PCI_SUBSYSTEM_DEVICE_ID = 0x7260 +default ROM_IMAGE_SIZE = 65536 +default STACK_SIZE = 0x2000 +default HEAP_SIZE = 0x8000 +default USE_OPTION_TABLE = (!USE_FALLBACK_IMAGE) && (!USE_FAILOVER_IMAGE) +default _RAMBASE = 0x00100000 +default CONFIG_ROM_PAYLOAD = 1 +default CONFIG_COMPRESSED_PAYLOAD_NRV2B = 1 # NRV2B compression +# default CONFIG_COMPRESSED_PAYLOAD_LZMA = 1 # LZMA compression +default CC = "$(CROSS_COMPILE)gcc -m32" +default HOSTCC = "gcc" +default CONFIG_USE_PRINTK_IN_CAR = 1 +default CONFIG_CONSOLE_SERIAL8250 = 1 +default TTYS0_BAUD = 115200 +default TTYS0_BASE = 0x3f8 +default TTYS0_LCS = 0x3 +default DEFAULT_CONSOLE_LOGLEVEL = 9 +default MAXIMUM_CONSOLE_LOGLEVEL = 9 +default MAINBOARD_POWER_ON_AFTER_POWER_FAIL = "MAINBOARD_POWER_ON" + +end |