diff options
Diffstat (limited to 'src/northbridge/intel/e7505/raminit.c')
-rw-r--r-- | src/northbridge/intel/e7505/raminit.c | 18 |
1 files changed, 9 insertions, 9 deletions
diff --git a/src/northbridge/intel/e7505/raminit.c b/src/northbridge/intel/e7505/raminit.c index 909e740131..b758c610f1 100644 --- a/src/northbridge/intel/e7505/raminit.c +++ b/src/northbridge/intel/e7505/raminit.c @@ -42,9 +42,9 @@ Definitions: //#define VALIDATE_DIMM_COMPATIBILITY #if CONFIG_DEBUG_RAM_SETUP -#define RAM_DEBUG_MESSAGE(x) print_debug(x) -#define RAM_DEBUG_HEX32(x) print_debug_hex32(x) -#define RAM_DEBUG_HEX8(x) print_debug_hex8(x) +#define RAM_DEBUG_MESSAGE(x) printk(BIOS_DEBUG, x) +#define RAM_DEBUG_HEX32(x) printk(BIOS_DEBUG, "%08x", x) +#define RAM_DEBUG_HEX8(x) printk(BIOS_DEBUG, "%02x", x) #define DUMPNORTH() dump_pci_device(MCHDEV) #else #define RAM_DEBUG_MESSAGE(x) @@ -605,7 +605,7 @@ static uint8_t spd_get_supported_dimms(const struct mem_controller *ctrl) spd_read_byte(channel1_dimm, SPD_MODULE_ATTRIBUTES); if (!(spd_value & MODULE_REGISTERED) || (spd_value < 0)) { - print_debug("Skipping un-matched DIMMs - only dual-channel operation supported\n"); + printk(BIOS_DEBUG, "Skipping un-matched DIMMs - only dual-channel operation supported\n"); continue; } #ifdef VALIDATE_DIMM_COMPATIBILITY @@ -633,11 +633,11 @@ static uint8_t spd_get_supported_dimms(const struct mem_controller *ctrl) // Made it through all the checks, this DIMM pair is usable dimm_mask |= ((1 << i) | (1 << (MAX_DIMM_SOCKETS_PER_CHANNEL + i))); } else - print_debug("Skipping un-matched DIMMs - only dual-channel operation supported\n"); + printk(BIOS_DEBUG, "Skipping un-matched DIMMs - only dual-channel operation supported\n"); #else switch (bDualChannel) { case 0: - print_debug("Skipping un-matched DIMMs - only dual-channel operation supported\n"); + printk(BIOS_DEBUG, "Skipping un-matched DIMMs - only dual-channel operation supported\n"); break; default: @@ -1379,13 +1379,13 @@ static void configure_e7501_dram_controller_mode(const struct die_on_spd_error(value); value &= 0x7f; // Mask off self-refresh bit if (value > MAX_SPD_REFRESH_RATE) { - print_err("unsupported refresh rate\n"); + printk(BIOS_ERR, "unsupported refresh rate\n"); continue; } // Get the appropriate E7501 refresh mode for this DIMM dimm_refresh_mode = refresh_rate_map[value]; if (dimm_refresh_mode > 7) { - print_err("unsupported refresh rate\n"); + printk(BIOS_ERR, "unsupported refresh rate\n"); continue; } // If this DIMM requires more frequent refresh than others, @@ -1767,7 +1767,7 @@ static void sdram_set_spd_registers(const struct mem_controller *ctrl) dimm_mask = spd_get_supported_dimms(ctrl); if (dimm_mask == 0) { - print_debug("No usable memory for this controller\n"); + printk(BIOS_DEBUG, "No usable memory for this controller\n"); } else { enable_e7501_clocks(dimm_mask); |