diff options
Diffstat (limited to 'src')
| -rw-r--r-- | src/soc/intel/common/block/smm/smihandler.c | 33 | ||||
| -rw-r--r-- | src/soc/intel/common/block/smm/smm.c | 17 |
2 files changed, 26 insertions, 24 deletions
diff --git a/src/soc/intel/common/block/smm/smihandler.c b/src/soc/intel/common/block/smm/smihandler.c index b620ff9f1e..7a4be47844 100644 --- a/src/soc/intel/common/block/smm/smihandler.c +++ b/src/soc/intel/common/block/smm/smihandler.c @@ -21,6 +21,7 @@ #include <cpu/x86/smm.h> #include <device/pci_def.h> #include <elog.h> +#include <intelblocks/pmclib.h> #include <intelblocks/smihandler.h> #include <soc/nvs.h> #include <soc/pm.h> @@ -73,7 +74,7 @@ static void *find_save_state(const struct smm_save_state_ops *save_state_ops, /* Inherited from cpu/x86/smm.h resulting in a different signature */ void southbridge_smi_set_eos(void) { - enable_smi(EOS); + pmc_enable_smi(EOS); } struct global_nvs_t *smm_get_gnvs(void) @@ -135,7 +136,7 @@ void smihandler_southbridge_sleep( uint8_t slp_typ; /* First, disable further SMIs */ - disable_smi(SLP_SMI_EN); + pmc_disable_smi(SLP_SMI_EN); /* Figure out SLP_TYP */ reg32 = inl(ACPI_BASE_ADDRESS + PM1_CNT); printk(BIOS_SPEW, "SMI#: SLP = 0x%08x\n", reg32); @@ -149,7 +150,7 @@ void smihandler_southbridge_sleep( elog_add_event_byte(ELOG_TYPE_ACPI_ENTER, slp_typ); /* Clear pending GPE events */ - clear_gpe_status(); + pmc_clear_gpe_status(); /* Next, do the deed. */ @@ -170,7 +171,7 @@ void smihandler_southbridge_sleep( printk(BIOS_DEBUG, "SMI#: Entering S5 (Soft Power off)\n"); /* Disable all GPE */ - disable_all_gpe(); + pmc_disable_all_gpe(); /* also iterates over all bridges on bus 0 */ busmaster_disable_on_bus(0); break; @@ -180,7 +181,7 @@ void smihandler_southbridge_sleep( } /* Clear the gpio gpe0 status bits in ACPI registers */ - clear_gpi_gpe_sts(); + pmc_clear_gpi_gpe_sts(); /* Tri-state specific GPIOS to avoid leakage during S3/S5 */ @@ -189,7 +190,7 @@ void smihandler_southbridge_sleep( * event again. We need to set BIT13 (SLP_EN) though to make the * sleep happen. */ - enable_pm1_control(SLP_EN); + pmc_enable_pm1_control(SLP_EN); /* Make sure to stop executing code here for S3/S4/S5 */ if (slp_typ >= ACPI_S3) @@ -203,7 +204,7 @@ void smihandler_southbridge_sleep( reg32 = inl(ACPI_BASE_ADDRESS + PM1_CNT); if (reg32 & SCI_EN) { /* The OS is not an ACPI OS, so we set the state to S0 */ - disable_pm1_control(SLP_EN | SLP_TYP); + pmc_disable_pm1_control(SLP_EN | SLP_TYP); } } @@ -269,11 +270,11 @@ void smihandler_southbridge_apmc( printk(BIOS_DEBUG, "P-state control\n"); break; case APM_CNT_ACPI_DISABLE: - disable_pm1_control(SCI_EN); + pmc_disable_pm1_control(SCI_EN); printk(BIOS_DEBUG, "SMI#: ACPI disabled.\n"); break; case APM_CNT_ACPI_ENABLE: - enable_pm1_control(SCI_EN); + pmc_enable_pm1_control(SCI_EN); printk(BIOS_DEBUG, "SMI#: ACPI enabled.\n"); break; case APM_CNT_GNVS_UPDATE: @@ -306,7 +307,7 @@ void smihandler_southbridge_apmc( void smihandler_southbridge_pm1( const struct smm_save_state_ops *save_state_ops) { - uint16_t pm1_sts = clear_pm1_status(); + uint16_t pm1_sts = pmc_clear_pm1_status(); /* * While OSPM is not active, poweroff immediately @@ -316,21 +317,21 @@ void smihandler_southbridge_pm1( /* power button pressed */ if (IS_ENABLED(CONFIG_ELOG_GSMI)) elog_add_event(ELOG_TYPE_POWER_BUTTON); - disable_pm1_control(-1UL); - enable_pm1_control(SLP_EN | (SLP_TYP_S5 << SLP_TYP_SHIFT)); + pmc_disable_pm1_control(-1UL); + pmc_enable_pm1_control(SLP_EN | (SLP_TYP_S5 << SLP_TYP_SHIFT)); } } void smihandler_southbridge_gpe0( const struct smm_save_state_ops *save_state_ops) { - clear_gpe_status(); + pmc_clear_gpe_status(); } void smihandler_southbridge_tco( const struct smm_save_state_ops *save_state_ops) { - uint32_t tco_sts = clear_tco_status(); + uint32_t tco_sts = pmc_clear_tco_status(); /* Any TCO event? */ if (!tco_sts) @@ -347,7 +348,7 @@ void smihandler_southbridge_periodic( { uint32_t reg32; - reg32 = get_smi_en(); + reg32 = pmc_get_smi_en(); /* Are periodic SMIs enabled? */ if ((reg32 & PERIODIC_EN) == 0) @@ -365,7 +366,7 @@ void southbridge_smi_handler(void) * We need to clear the SMI status registers, or we won't see what's * happening in the following calls. */ - smi_sts = clear_smi_status(); + smi_sts = pmc_clear_smi_status(); save_state_ops = get_smm_save_state_ops(); diff --git a/src/soc/intel/common/block/smm/smm.c b/src/soc/intel/common/block/smm/smm.c index ab60af615d..41f3426c11 100644 --- a/src/soc/intel/common/block/smm/smm.c +++ b/src/soc/intel/common/block/smm/smm.c @@ -17,6 +17,7 @@ #include <console/console.h> #include <cpu/x86/smm.h> +#include <intelblocks/pmclib.h> #include <intelblocks/smm.h> #include <soc/pm.h> @@ -24,24 +25,24 @@ void smm_southbridge_clear_state(void) { printk(BIOS_DEBUG, "Clearing SMI status registers\n"); - if (get_smi_en() & APMC_EN) { + if (pmc_get_smi_en() & APMC_EN) { printk(BIOS_INFO, "SMI# handler already enabled?\n"); return; } /* Dump and clear status registers */ - clear_smi_status(); - clear_pm1_status(); - clear_tco_status(); - clear_gpe_status(); + pmc_clear_smi_status(); + pmc_clear_pm1_status(); + pmc_clear_tco_status(); + pmc_clear_gpe_status(); } void smm_southbridge_enable(void) { printk(BIOS_DEBUG, "Enabling SMIs.\n"); /* Configure events */ - enable_pm1(PWRBTN_EN | GBL_EN); - disable_gpe(PME_B0_EN); + pmc_enable_pm1(PWRBTN_EN | GBL_EN); + pmc_disable_gpe(PME_B0_EN); /* * Enable SMI generation: @@ -55,7 +56,7 @@ void smm_southbridge_enable(void) */ /* Enable SMI generation: */ - enable_smi(ENABLE_SMI_PARAMS); + pmc_enable_smi(ENABLE_SMI_PARAMS); } void smm_setup_structures(void *gnvs, void *tcg, void *smi1) |