summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2014-11-14AMD (K8/fam10): Rewrite CAR migration in post_cache_as_ramKyösti Mälkki
2014-11-14build system: improve portabilityPatrick Georgi
2014-11-14mainboard: Remove commented include lines for mc146818rtc.hEdward O'Callaghan
2014-11-14tegra124: allow tegra124 devices to run vboot rmoduleAaron Durbin
2014-11-14Big, Blaze: Set I2S1 Source to CLK_M to Fix BeepDaisuke Nojiri
2014-11-14nyan: tpm: Increase the TPM frequency to 400 KHz.Gabe Black
2014-11-14tegra124: i2c: Reset the controller when there's an error.Gabe Black
2014-11-14tegra124: fix the dangerous VPR write orderJoseph Lo
2014-11-14tegra124: Add some functions for resetting peripherals.Gabe Black
2014-11-14Nyan: Set I2S1 Source to CLK_MDaisuke Nojiri
2014-11-14nyan: Move some pinmux and clock/reset configuration to ROM stage.Gabe Black
2014-11-14t124: Clean up display init functionsJimmy Zhang
2014-11-14blaze: Create a nyan_blaze mainboard, copied from nyan_bigTom Warren
2014-11-13AMD Trinity: Update the Trinity SMU FirmwareZheng Bao
2014-11-13intel: use crosscompiler readelf, instead of globalPatrick Georgi
2014-11-13arm: Put assembly functions into separate sectionsJulius Werner
2014-11-13vboot: provide empty vboot_verify_firmware()Aaron Durbin
2014-11-13qemu-armv7: Minimal changes to pass compiling qemu-v7 platform.Hung-Te Lin
2014-11-13ipq8064: Make timer code compileVadim Bendebury
2014-11-13ipq8064: Configure proper bootblock stack and load addressVadim Bendebury
2014-11-13Use sbl blobs from a private locationVadim Bendebury
2014-11-13ipq806x: Add support for GPIO operationsFurquan Shaikh
2014-11-13nyan*: Switching unused pin to GPIONeil Chen
2014-11-13nyan: big: Only delay when and as long as necessary in the PMIC setup code.Gabe Black
2014-11-13nyan: big: Set the i2c controller frequencies appropriately.Gabe Black
2014-11-13tegra124: Add a macro specifically for configuring the I2C controller clocks.Gabe Black
2014-11-13tegra124: Fix some bugs in the clock configuration macros.Gabe Black
2014-11-13t124: Skip PLLP init to 408MHzJimmy Zhang
2014-11-13t124: nyan: Enable lock bit on pllJimmy Zhang
2014-11-13Nyan: Set DMA Reserve to 2MBDaisuke Nojiri
2014-11-13tegra124: fix OSC initialization on LP0 resumeAndrew Bresticker
2014-11-13tegra124: fix PLLU parametersAndrew Bresticker
2014-11-13nyan: Select the CD570M Tegra124 model.Gabe Black
2014-11-13tegra124: Make the PLLX frequency selectable by model.Gabe Black
2014-11-13nyan: Update 924MHz BCT w/latest qual'd cfg, use 924 as default speed for 2GBTom Warren
2014-11-13nyan: nyan_big: Mark the address range covering the SRAM as cachable.Gabe Black
2014-11-13nyan: Add 4GB bct supportJimmy Zhang
2014-11-13nyan: big: Check dram_end when setting up caching in ROM stage.Gabe Black
2014-11-13libpayload: Add minimal support for PL011 UARTMarcelo Povoa
2014-11-13libpayload: timer: Move the timer drivers from depthcharge to libpayload.Gabe Black
2014-11-13libpayload: usb: Remove automatic clear_stall() calls from transfersJulius Werner
2014-11-13libpayload: usb: Fix up usb_shutdown() code pathsJulius Werner
2014-11-13libpayload: Remove config.pantherMarc Jones
2014-11-13libpayload: Update defconfigsMarc Jones
2014-11-13vendorcode/amd/agesa/f1{0,2,4,5}: Typo in header guardEdward O'Callaghan
2014-11-12ipq806x: Typecast address to void * in read/write operationsFurquan Shaikh
2014-11-12ipq806x: Add an include/ folder to ipq806xFurquan Shaikh
2014-11-12gm45: Don't crash if less than 4G of RAM are present.Vladimir Serbinenko
2014-11-12Copy u-boot sources as is and modify the tree to still buildVadim Bendebury
2014-11-12Include IPQ8064 SBLs code in the coreboot bootblockVadim Bendebury
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-09 20:44:59 +0000