summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2015-04-15soc/broadwell: Use microcode from the blobs repositoryMarc Jones
2015-04-15veyron: Add "backlight" GPIO to coreboot tableJulius Werner
2015-04-15brain: remove sdmmc_power_off() in romstageDavid Hendricks
2015-04-15veyron_danger: Enable EDP display initDavid Hendricks
2015-04-15Danger: Apply differences between Brain and DangerDavid Hendricks
2015-04-15Danger: Initial mainboard importDavid Hendricks
2015-04-15rk3288: send correct EDID buffer sizehuang lin
2015-04-15rk808: Implement RTC driverDavid Hendricks
2015-04-15veyron_*: Move PMIC_BUS to a Kconfig variableDavid Hendricks
2015-04-15rk3288: Implement support for CRYPTO module and use it in vboot hashingJulius Werner
2015-04-15veyron: add H9CCNNN8GTMLAR sdram in speedyJiazi Yang
2015-04-15veyron: Support Speedy v1 hardwarehuang lin
2015-04-15Brain: Apply differences between Jerry and BrainDavid Hendricks
2015-04-15Brain: Initial mainboard importDavid Hendricks
2015-04-15blaze: add new Micron 2GB BCTNeil Chen
2015-04-15veyron: Fix TPM I2C initialization and sync boardsJulius Werner
2015-04-15veyron_*: Use common CBFS wrapperDavid Hendricks
2015-04-15veyron: Support Mighty v1 hardwarehuang lin
2015-04-15veyron: Support Jerry v3 hardwarehuang lin
2015-04-15veyron: Support Pinky v4 hardwarehuang lin
2015-04-15veyron: Move backlight gpio control to mainboard.chuang lin
2015-04-15veyron: Trigger hard reset (via GPIO) if last reboot was caused by watchdogJulius Werner
2015-04-15veyron_speedy: Support Samsung-4GB and Lynix-4GB LPDDRhuang lin
2015-04-15veyron: Add veyron_speedy boardhuang lin
2015-04-15veyron: Turn off SD card power in romstageJulius Werner
2015-04-15rk3288: implement spi_crop_chunk()Patrick Georgi
2015-04-15Kconfig: Fix incorrect CONFIG_STACK_SIZE values for X86 and ARM64Julius Werner
2015-04-14Add console wrapper for UART driverVadim Bendebury
2015-04-14libpayload: avoid hanging on make junit.xmlPatrick Georgi
2015-04-14storm: do not enable the ethernet switch by defaultVadim Bendebury
2015-04-14samus: Declare TPM in devicetree.cb and include ACPI deviceDuncan Laurie
2015-04-14broadwell: Remove TPM device from lpc.aslDuncan Laurie
2015-04-14wtm2/samus: fix coreboot compilation error with tpmp removedHarry Pan
2015-04-14urara: increase drive strength for SPIM1 MFIOsIonela Voinescu
2015-04-14urara: setup I2C0 clock and MFIOsIonela Voinescu
2015-04-14pistachio: implement clock setup for I2C0Ionela Voinescu
2015-04-14pistachio: modify timer to account for CPU counter overflowIonela Voinescu
2015-04-14urara: Reduce MIPS PLL jitterIonela Voinescu
2015-04-14pistachio: Fix ROM clock base addressIonela Voinescu
2015-04-14urara: add clock setup for MIPS CPU, ROM and EthernetIonela Voinescu
2015-04-14urara: remove call to printk before UART is initializedIonela Voinescu
2015-04-14pistachio: fix clocks setup codeIonela Voinescu
2015-04-14pistachio: Use 1.8433179 MHz for UART refclkDavid Hendricks
2015-04-14pistachio: increase size of bootblock to 18 KBIonela Voinescu
2015-04-14pistachio: change memory layout as to allow bigger CBFS cacheIonela Voinescu
2015-04-14pistachio: spi: use same clock edge for RX and TXIonela Voinescu
2015-04-14urara: Configure clocks and MFIOsIonela Voinescu
2015-04-14arm64: Increase dma region size to 32MiBFurquan Shaikh
2015-04-14tegra132: lock down VPRAaron Durbin
2015-04-14libpayload dwc2: use bus addresses for buffersIonela Voinescu