summaryrefslogtreecommitdiff
path: root/src/mainboard/google/gru
AgeCommit message (Expand)Author
2017-05-05google/scarlet: Enable innolux,p079zca MIPI panelNickey Yang
2017-05-03google/gru: skip usbphy1 setup for Scarletphilipchen
2017-04-28google/gru: tpm on bob: cr50: add irq clear/irq status for tpm irqJeffy Chen
2017-04-25google/gru: change the sd power sequenceCaesar Wang
2017-04-24Kconfig: provide MAINBOARD_HAS_TPM_CR50 optionAaron Durbin
2017-04-19google/gru: change kevin boot-time center logic voltage to 925mVDouglas Anderson
2017-04-19google/gru: change center logic voltage to 900mVDerek Basehore
2017-04-11scarlet/gru: skip display because mipi driver not readyShunqian Zheng
2017-04-06gru: Initialize I2C bus for ARC2C0608Philip Chen
2017-03-28vboot: Move remaining features out of vendorcode/google/chromeosJulius Werner
2017-03-28vboot: Assume EC_SOFTWARE_SYNC and VIRTUAL_DEV_SWITCH by defaultJulius Werner
2017-03-09drivers/spi/tpm: provide Kconfig to indicate CR50 usageAaron Durbin
2017-03-07google/gru: add MAX_SDRAM_FREQ config to choose max ddr freqShunqian Zheng
2017-02-23google/gru: whitespace fixPatrick Georgi
2017-02-23google/gru: Tuning USB 2.0 PHY0 and PHY1 squelch detection thresholdWilliam wu
2017-02-23google/gru: update the pwm regulatorCaesar Wang
2017-02-23google/gru: improve eye diagram for passing the testCaesar Wang
2017-02-22google/gru: Fix whitespacePatrick Georgi
2017-02-11google/gru: add scarlet variantphilipchen
2017-01-22gru: kevin: define GPIOs used on both platformsVadim Bendebury
2017-01-13gru: Tuning USB 2.0 PHY0 and PHY1 host-portWilliam wu
2016-12-06Bob: Update the memory ramid of bobShasha Zhao
2016-12-06Bob: add bob in corebootShasha Zhao
2016-12-06rockchip/rk3399: sdram: use register to calculate sdram sizesLin Huang
2016-12-06google/gru: Power-cycle USB ports in developer/recovery modesJulius Werner
2016-12-01lib: put romstage_handoff implementation in own compilation unitAaron Durbin
2016-11-29google/gru: Tune USB 2.0 PHY to increase compatibilityWilliam wu
2016-11-18google/chromeec: Add common infrastructure for boot-mode switchesFurquan Shaikh
2016-11-17google/gru: Move to one CA training patternDerek Basehore
2016-11-17google/gru: Add new CA training patternDerek Basehore
2016-11-02rockchip/rk3399: display: Do not allocate framebuffer in corebootLin Huang
2016-11-02rockchip/rk3399: sdram: also prepare the index1 configurationLin Huang
2016-10-25rockchip/rk3399: gru/kevin: drop unused sdram configsLin Huang
2016-10-25rockchip/rk3399: reset system if DDR init failsLin Huang
2016-10-08google/gru: Add USB 2.0 PHY tuning for Kevin PHY0 and PHY1William wu
2016-10-07google/gru: drive WLAN_MODULE_RST# low as early as possibleBrian Norris
2016-10-07google/gru: set W2W_DIFFCS_DLY to 5Lin Huang
2016-10-07google/gru: pass apio number to arm-trust-firmwareLin Huang
2016-10-07google/gru: pass the gpio power supply enable pin to bl31Lin Huang
2016-10-06rockchip: rk3399: improve write leveling flowJianqun Xu
2016-10-06google/gru: Shrink RW_ELOG region to 4KBJulius Werner
2016-10-06rockchip: rk3399: improve sdram noc timingLin Huang
2016-10-06rockchip/rk3399: lower kevin board sdram frequency to 800MHzLin Huang
2016-10-06rockchip/rk3399: Move big CPU cluster initialization into ramstageJulius Werner
2016-10-04google/gru: Ensure correct pull resistors for special-function pinsJulius Werner
2016-10-04gru: Increase SPI speed to 33MHzSimon Glass
2016-10-04google/gru: Init the PWM pinmux after setting up the PWMDouglas Anderson
2016-10-02Kconfig: Update default hex values to start with 0xMartin Roth
2016-09-20gru/kevin: Decrease voltage for little cpu 1.5G to 1.15vShunqian Zheng
2016-09-20google/gru: Fix up PWM regulator rangesJulius Werner