From 7dc2864be7fcc342bab0c167997803f5faf147a1 Mon Sep 17 00:00:00 2001 From: Patrick Georgi Date: Fri, 13 Jul 2012 19:06:22 +0200 Subject: amd/lx: Move configuration from source to Kconfig LX has two values that are usually automatically derived but can be overridden, that were so far defined in each board's romstage. These values, along with the toggle to enable override are now part of LX's Kconfig. For boards that gave values but requested autogeneration, the values are removed. Further improvements: Figure out the various fields in PLLMSRlo and make them sensible Kconfig options (instead of the hex value it is now) Change-Id: I8a17c89e4a3cb1b52aaceef645955ab7817b482d Signed-off-by: Patrick Georgi Reviewed-on: http://review.coreboot.org/1227 Tested-by: build bot (Jenkins) Reviewed-by: Stefan Reinauer --- src/mainboard/lippert/hurricane-lx/Kconfig | 6 ++++++ src/mainboard/lippert/hurricane-lx/romstage.c | 6 +----- 2 files changed, 7 insertions(+), 5 deletions(-) (limited to 'src/mainboard/lippert/hurricane-lx') diff --git a/src/mainboard/lippert/hurricane-lx/Kconfig b/src/mainboard/lippert/hurricane-lx/Kconfig index 118809d333..64e16318c4 100644 --- a/src/mainboard/lippert/hurricane-lx/Kconfig +++ b/src/mainboard/lippert/hurricane-lx/Kconfig @@ -13,6 +13,8 @@ config BOARD_SPECIFIC_OPTIONS # dummy # Board is equipped with a 1 MB SPI flash, however, due to limitations # of the IT8712F Super I/O, only the top 512 KB are directly mapped. select BOARD_ROMSIZE_KB_512 + select PLL_MANUAL_CONFIG + select CORE_GLIU_500_333 config MAINBOARD_DIR string @@ -50,4 +52,8 @@ config ONBOARD_UARTS_RS485 If selected, both on-board serial ports will operate in RS485 mode instead of RS232. +config PLLMSRlo + hex + default 0x00de6001 + endif # BOARD_LIPPERT_HURRICANE_LX diff --git a/src/mainboard/lippert/hurricane-lx/romstage.c b/src/mainboard/lippert/hurricane-lx/romstage.c index 29aa9d1e4f..b2ee033013 100644 --- a/src/mainboard/lippert/hurricane-lx/romstage.c +++ b/src/mainboard/lippert/hurricane-lx/romstage.c @@ -40,10 +40,6 @@ /* Bit0 enables Spread Spectrum. */ #define SMC_CONFIG 0x01 -#define ManualConf 1 /* No automatic strapped PLL config */ -#define PLLMSRhi 0x0000049C /* Manual settings for the PLL */ -#define PLLMSRlo 0x00DE6001 - static inline int spd_read_byte(unsigned int device, unsigned int address) { if (device != DIMM0) @@ -138,7 +134,7 @@ void main(unsigned long bist) /* Halt if there was a built in self test failure */ report_bist_failure(bist); - pll_reset(ManualConf); + pll_reset(); cpuRegInit(0, DIMM0, DIMM1, DRAM_TERMINATED); -- cgit v1.2.3