From 6d6c00a50237dd8c9102fd24cb183ceda1aa90ac Mon Sep 17 00:00:00 2001 From: Martin Roth Date: Fri, 30 Sep 2016 14:51:24 -0600 Subject: google/gale: Remove #ifdef of Kconfig bool symbol Kconfig symbols of type bool are ALWAYS defined, so this code was always being included and run, which isn't what the author wanted. Change to use IS_ENABLED(), and a regular if() instead of an #ifdef. Change-Id: I72623fa27e47980c602135f4b73f371c7f50139b Signed-off-by: Martin Roth Reviewed-on: https://review.coreboot.org/16837 Tested-by: build bot (Jenkins) Reviewed-by: Stefan Reinauer --- src/mainboard/google/gale/verstage.c | 55 ++++++++++++++++++------------------ 1 file changed, 27 insertions(+), 28 deletions(-) (limited to 'src') diff --git a/src/mainboard/google/gale/verstage.c b/src/mainboard/google/gale/verstage.c index cdc4386988..1a3f5a49bd 100644 --- a/src/mainboard/google/gale/verstage.c +++ b/src/mainboard/google/gale/verstage.c @@ -24,34 +24,33 @@ static void ipq_setup_tpm(void) { -#ifdef CONFIG_I2C_TPM - gpio_tlmm_config_set(TPM_RESET_GPIO, FUNC_SEL_GPIO, - GPIO_PULL_UP, GPIO_6MA, 1); - gpio_set(TPM_RESET_GPIO, 0); - udelay(100); - gpio_set(TPM_RESET_GPIO, 1); - - /* - * ----- Per the SLB 9615XQ1.2 spec ----- - * - * 4.7.1 Reset Timing - * - * The TPM_ACCESS_x.tpmEstablishment bit has the correct value - * and the TPM_ACCESS_x.tpmRegValidSts bit is typically set - * within 8ms after RESET# is deasserted. - * - * The TPM is ready to receive a command after less than 30 ms. - * - * -------------------------------------- - * - * I'm assuming this means "wait for 30ms" - * - * If we don't wait here, subsequent QUP I2C accesses - * to the TPM either fail or timeout. - */ - mdelay(30); - -#endif /* CONFIG_I2C_TPM */ + if (IS_ENABLED(CONFIG_I2C_TPM)) { + gpio_tlmm_config_set(TPM_RESET_GPIO, FUNC_SEL_GPIO, + GPIO_PULL_UP, GPIO_6MA, 1); + gpio_set(TPM_RESET_GPIO, 0); + udelay(100); + gpio_set(TPM_RESET_GPIO, 1); + + /* + * ----- Per the SLB 9615XQ1.2 spec ----- + * + * 4.7.1 Reset Timing + * + * The TPM_ACCESS_x.tpmEstablishment bit has the correct value + * and the TPM_ACCESS_x.tpmRegValidSts bit is typically set + * within 8ms after RESET# is deasserted. + * + * The TPM is ready to receive a command after less than 30 ms. + * + * -------------------------------------- + * + * I'm assuming this means "wait for 30ms" + * + * If we don't wait here, subsequent QUP I2C accesses + * to the TPM either fail or timeout. + */ + mdelay(30); + } } void verstage_mainboard_init(void) -- cgit v1.2.3