/* the problem: we have 82801dbm support in fb1, and 82801er in fb2. 
 * fb1 code is what we want, fb2 structure is needed however. 
 * so we need to get fb1 code for 82801dbm into fb2 structure. 
 */
/* What I did: took the 80801er stuff from fb2, verify it against the 
 * db stuff in fb1, and made sure it was right.
 */

#ifndef I82801DBM_H
#define I82801DBM_H

#include "chip.h"
extern void i82801dbm_enable(device_t dev);

/*
000 = Non-combined. P0 is primary master. P1 is secondary master.
001 = Non-combined. P0 is secondary master. P1 is primary master.
100 = Combined. P0 is primary master. P1 is primary slave. IDE is secondary; Primary IDE channel
disabled.
101 = Combined. P0 is primary slave. P1 is primary master. IDE is secondary.
110 = Combined. IDE is primary. P0 is secondary master. P1 is secondary slave; Secondary IDE
channel disabled.
111 = Combined. IDE is primary. P0 is secondary slave. P1 is secondary master.
*/

#define PCI_DMA_CFG     0x90
#define SERIRQ_CNTL     0x64
#define GEN_CNTL        0xd0
#define GEN_STS         0xd4
#define RTC_CONF        0xd8
#define GEN_PMCON_3     0xa4

#define PCICMD          0x04
#define PMBASE          0x40
#define ACPI_CNTL       0x44
#define BIOS_CNTL       0x4E
#define GPIO_BASE       0x58
#define GPIO_CNTL       0x5C
#define PIRQA_ROUT      0x60
#define PIRQE_ROUT      0x68
#define COM_DEC         0xE0
#define LPC_EN          0xE6
#define FUNC_DIS        0xF2

/* 1e f0 244e */

#define CMD             0x04
#define SBUS_NUM        0x19
#define SUB_BUS_NUM     0x1A
#define SMLT            0x1B
#define IOBASE          0x1C
#define IOLIM           0x1D
#define MEMBASE         0x20
#define MEMLIM          0x22
#define CNF             0x50
#define MTT             0x70
#define PCI_MAST_STS    0x82

#define RTC_FAILED      (1 <<2)


#define SMBUS_IO_BASE 0x1000

#define SMBHSTSTAT 0x0
#define SMBHSTCTL  0x2
#define SMBHSTCMD  0x3
#define SMBXMITADD 0x4
#define SMBHSTDAT0 0x5
#define SMBHSTDAT1 0x6
#define SMBBLKDAT  0x7
#define SMBTRNSADD 0x9
#define SMBSLVDATA 0xa
#define SMLINK_PIN_CTL 0xe
#define SMBUS_PIN_CTL  0xf 

/* Between 1-10 seconds, We should never timeout normally 
 * Longer than this is just painful when a timeout condition occurs.
 */
#define SMBUS_TIMEOUT (100*1000)

#endif /* I82801DBM_H */