/* SPDX-License-Identifier: GPL-2.0-or-later */ #include #include #include #include "it8772f.h" /* NOTICE: This file is deprecated, use ite/common instead */ void it8772f_enter_conf(pnp_devfn_t dev) { u16 port = dev >> 8; outb(0x87, port); outb(0x01, port); outb(0x55, port); outb((port == 0x4e) ? 0xaa : 0x55, port); } void it8772f_exit_conf(pnp_devfn_t dev) { pnp_write_config(dev, IT8772F_CONFIG_REG_CC, 0x02); } /* Set AC resume to be up to the Southbridge */ void it8772f_ac_resume_southbridge(pnp_devfn_t dev) { it8772f_enter_conf(dev); pnp_write_config(dev, IT8772F_CONFIG_REG_LDN, IT8772F_EC); pnp_write_config(dev, PNP_IDX_MSC4, 0x60); it8772f_exit_conf(dev); } /* Configure a set of GPIOs */ void it8772f_gpio_setup(pnp_devfn_t dev, int set, u8 select, u8 polarity, u8 pullup, u8 output, u8 enable) { set--; /* Set 1 is offset 0 */ it8772f_enter_conf(dev); pnp_write_config(dev, IT8772F_CONFIG_REG_LDN, IT8772F_GPIO); if (set < 5) { pnp_write_config(dev, GPIO_REG_SELECT(set), select); pnp_write_config(dev, GPIO_REG_ENABLE(set), enable); pnp_write_config(dev, GPIO_REG_POLARITY(set), polarity); } pnp_write_config(dev, GPIO_REG_OUTPUT(set), output); pnp_write_config(dev, GPIO_REG_PULLUP(set), pullup); it8772f_exit_conf(dev); } /* Configure LED GPIOs */ void it8772f_gpio_led(pnp_devfn_t dev,int set, u8 select, u8 polarity, u8 pullup, u8 output, u8 enable, u8 led_pin_map, u8 led_freq) { set--; /* Set 1 is offset 0 */ it8772f_enter_conf(dev); pnp_write_config(dev, IT8772F_CONFIG_REG_LDN, IT8772F_GPIO); if (set < 5) { pnp_write_config(dev, IT8772F_GPIO_LED_BLINK1_PINMAP, led_pin_map); pnp_write_config(dev, IT8772F_GPIO_LED_BLINK1_CONTROL, led_freq); pnp_write_config(dev, GPIO_REG_SELECT(set), select); pnp_write_config(dev, GPIO_REG_ENABLE(set), enable); pnp_write_config(dev, GPIO_REG_POLARITY(set), polarity); } pnp_write_config(dev, GPIO_REG_OUTPUT(set), output); pnp_write_config(dev, GPIO_REG_PULLUP(set), pullup); it8772f_exit_conf(dev); }