1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
|
#include <stdint.h>
#include <string.h>
#include <device/pci_def.h>
#include <device/pci_ids.h>
#include <arch/io.h>
#include <device/pnp_def.h>
#include <pc80/mc146818rtc.h>
#include <console/console.h>
#include <cpu/amd/model_fxx_rev.h>
#include "southbridge/amd/amd8111/early_smbus.c"
#include "northbridge/amd/amdk8/raminit.h"
#include "northbridge/amd/amdk8/reset_test.c"
#include "cpu/x86/bist.h"
#include "lib/delay.c"
#include "northbridge/amd/amdk8/debug.c"
#include "superio/winbond/w83627hf/early_serial.c"
#include "northbridge/amd/amdk8/setup_resource_map.c"
#include "southbridge/amd/amd8111/early_ctrl.c"
#define SERIAL_DEV PNP_DEV(0x2e, W83627HF_SP1)
/*
* GPIO28 of 8111 will control H0_MEMRESET_L
* GPIO29 of 8111 will control H1_MEMRESET_L
*/
static void memreset_setup(void)
{
if (is_cpu_pre_c0()) {
/* Set the memreset low. */
outb((1<<2)|(0<<0), SMBUS_IO_BASE + 0xc0 + 28);
/* Ensure the BIOS has control of the memory lines. */
outb((1<<2)|(0<<0), SMBUS_IO_BASE + 0xc0 + 29);
} else {
/* Ensure the CPU has control of the memory lines. */
outb((1<<2)|(1<<0), SMBUS_IO_BASE + 0xc0 + 29);
}
}
static void memreset(int controllers, const struct mem_controller *ctrl)
{
if (is_cpu_pre_c0()) {
udelay(800);
/* Set memreset_high */
outb((1<<2)|(1<<0), SMBUS_IO_BASE + 0xc0 + 28);
udelay(90);
}
}
static void activate_spd_rom(const struct mem_controller *ctrl) { }
static inline int spd_read_byte(unsigned device, unsigned address)
{
return smbus_read_byte(device, address);
}
#include "northbridge/amd/amdk8/amdk8.h"
#include "northbridge/amd/amdk8/incoherent_ht.c"
#include "northbridge/amd/amdk8/coherent_ht.c"
#include "northbridge/amd/amdk8/raminit.c"
#include "lib/generic_sdram.c"
#include "resourcemap.c"
#include "cpu/amd/dualcore/dualcore.c"
#include <spd.h>
#include "cpu/amd/model_fxx/init_cpus.c"
#include "cpu/amd/model_fxx/fidvid.c"
void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
{
static const uint16_t spd_addr[] = {
// first node
DIMM0, DIMM2, 0, 0,
DIMM1, DIMM3, 0, 0,
// second node
DIMM4, DIMM6, 0, 0,
DIMM5, DIMM7, 0, 0,
};
struct sys_info *sysinfo = &sysinfo_car;
int needs_reset;
unsigned bsp_apicid = 0;
if (bist == 0)
bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);
w83627hf_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);
console_init();
/* Halt if there was a built in self test failure */
report_bist_failure(bist);
printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1);
setup_mb_resource_map();
print_debug("bsp_apicid="); print_debug_hex8(bsp_apicid); print_debug("\n");
setup_coherent_ht_domain(); // routing table and start other core0
wait_all_core0_started();
#if CONFIG_LOGICAL_CPUS
// It is said that we should start core1 after all core0 launched
/* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain,
* So here need to make sure last core0 is started, esp for two way system,
* (there may be apic id conflicts in that case)
*/
start_other_cores();
wait_all_other_cores_started(bsp_apicid);
#endif
/* it will set up chains and store link pair for optimization later */
ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn
#if CONFIG_SET_FIDVID
{
msr_t msr;
msr=rdmsr(0xc0010042);
print_debug("begin msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
}
enable_fid_change();
enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
init_fidvid_bsp(bsp_apicid);
// show final fid and vid
{
msr_t msr;
msr=rdmsr(0xc0010042);
print_debug("end msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
}
#endif
needs_reset = optimize_link_coherent_ht();
needs_reset |= optimize_link_incoherent_ht(sysinfo);
// fidvid change will issue one LDTSTOP and the HT change will be effective too
if (needs_reset) {
print_info("ht reset -\n");
soft_reset_x(sysinfo->sbbusn, sysinfo->sbdn);
}
allow_all_aps_stop(bsp_apicid);
//It's the time to set ctrl in sysinfo now;
fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr);
enable_smbus();
#if 0
dump_smbus_registers();
#endif
memreset_setup();
//do we need apci timer, tsc...., only debug need it for better output
/* all ap stopped? */
init_timer(); // Need to use TMICT to synconize FID/VID
sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo);
#if 0
dump_pci_devices();
#endif
post_cache_as_ram(); // bsp swtich stack to ram and copy sysinfo ram now
}
|