1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
|
/* SPDX-License-Identifier: GPL-2.0-only */
/* This file is part of the coreboot project. */
#include <bootmode.h>
#include <cbmem.h>
#include <commonlib/helpers.h>
#include <console/console.h>
#include <device/pci.h>
#include <device/pci_ops.h>
#include <device/resource.h>
#include <drivers/intel/gma/i915.h>
#include <drivers/intel/gma/i915_reg.h>
#include <drivers/intel/gma/libgfxinit.h>
#include <intelblocks/graphics.h>
#include <drivers/intel/gma/opregion.h>
#include <soc/nvs.h>
#include <soc/ramstage.h>
#include <types.h>
uintptr_t fsp_soc_get_igd_bar(void)
{
return graphics_get_memory_base();
}
static void graphics_setup_panel(struct device *dev)
{
struct soc_intel_skylake_config *conf = config_of(dev);
struct resource *mmio_res;
uint8_t *base;
u32 reg32;
if (!conf)
return;
mmio_res = find_resource(dev, PCI_BASE_ADDRESS_0);
if (!mmio_res || !mmio_res->base)
return;
base = (void *)(uintptr_t)mmio_res->base;
reg32 = conf->gpu_pp_up_delay_ms * 10 << 16;
reg32 |= conf->gpu_pp_backlight_on_delay_ms * 10;
write32(base + PCH_PP_ON_DELAYS, reg32);
reg32 = conf->gpu_pp_down_delay_ms * 10 << 16;
reg32 |= conf->gpu_pp_backlight_off_delay_ms * 10;
write32(base + PCH_PP_OFF_DELAYS, reg32);
reg32 = read32(base + PCH_PP_DIVISOR);
reg32 &= ~0x1f;
reg32 |= (DIV_ROUND_UP(conf->gpu_pp_cycle_delay_ms, 100) + 1) & 0x1f;
write32(base + PCH_PP_DIVISOR, reg32);
/* So far all devices seem to use the PCH PWM function.
The CPU PWM registers are all zero after reset. */
if (conf->gpu_pch_backlight_pwm_hz) {
/* Reference clock is 24MHz. We can choose either a 16
or a 128 step increment. Use 16 if we would have less
than 100 steps otherwise. */
const unsigned int hz_limit = 24 * 1000 * 1000 / 128 / 100;
unsigned int pwm_increment, pwm_period;
u32 south_chicken1;
south_chicken1 = read32(base + SOUTH_CHICKEN1);
if (conf->gpu_pch_backlight_pwm_hz > hz_limit) {
pwm_increment = 16;
south_chicken1 &= ~1;
} else {
pwm_increment = 128;
south_chicken1 |= 1;
}
write32(base + SOUTH_CHICKEN1, south_chicken1);
pwm_period = 24 * 1000 * 1000 / pwm_increment
/ conf->gpu_pch_backlight_pwm_hz;
/* Start with a 50% duty cycle. */
write32(base + BLC_PWM_PCH_CTL2,
pwm_period << 16 | pwm_period / 2);
write32(base + BLC_PWM_PCH_CTL1,
!!conf->gpu_pch_backlight_polarity << 29 |
BLM_PCH_PWM_ENABLE);
}
}
void graphics_soc_init(struct device *dev)
{
u32 ddi_buf_ctl;
graphics_setup_panel(dev);
/*
* Enable DDI-A (eDP) 4-lane operation if the link is not up yet.
* This will allow the kernel to use 4-lane eDP links properly
* if the VBIOS or GOP driver does not execute.
*/
ddi_buf_ctl = graphics_gtt_read(DDI_BUF_CTL_A);
if (!acpi_is_wakeup_s3() && !(ddi_buf_ctl & DDI_BUF_CTL_ENABLE)) {
ddi_buf_ctl |= DDI_A_4_LANES;
graphics_gtt_write(DDI_BUF_CTL_A, ddi_buf_ctl);
}
/* IGD needs to Bus Master */
u32 reg32 = pci_read_config32(dev, PCI_COMMAND);
reg32 |= PCI_COMMAND_MASTER | PCI_COMMAND_MEMORY | PCI_COMMAND_IO;
pci_write_config32(dev, PCI_COMMAND, reg32);
/*
* GFX PEIM module inside FSP binary is taking care of graphics
* initialization based on RUN_FSP_GOP Kconfig option and input
* VBT file.
*
* In case of non-FSP solution, SoC need to select another
* Kconfig to perform GFX initialization.
*/
if (CONFIG(RUN_FSP_GOP)) {
/* nothing to do */
} else if (CONFIG(MAINBOARD_USE_LIBGFXINIT)) {
if (!acpi_is_wakeup_s3() && display_init_required()) {
int lightup_ok;
gma_gfxinit(&lightup_ok);
gfx_set_init_done(lightup_ok);
}
} else {
/* Initialize PCI device, load/execute BIOS Option ROM */
pci_dev_init(dev);
}
intel_gma_restore_opregion();
}
uintptr_t gma_get_gnvs_aslb(const void *gnvs)
{
const global_nvs_t *gnvs_ptr = gnvs;
return (uintptr_t)(gnvs_ptr ? gnvs_ptr->aslb : 0);
}
void gma_set_gnvs_aslb(void *gnvs, uintptr_t aslb)
{
global_nvs_t *gnvs_ptr = gnvs;
if (gnvs_ptr)
gnvs_ptr->aslb = aslb;
}
/* Initialize IGD OpRegion, called from ACPI code */
static void update_igd_opregion(igd_opregion_t *opregion)
{
/* FIXME: Add platform specific mailbox initialization */
}
uintptr_t graphics_soc_write_acpi_opregion(struct device *device,
uintptr_t current, struct acpi_rsdp *rsdp)
{
igd_opregion_t *opregion;
global_nvs_t *gnvs = cbmem_find(CBMEM_ID_ACPI_GNVS);
/* If GOP is not used, exit here */
if (!CONFIG(INTEL_GMA_ADD_VBT))
return current;
/* If IGD is disabled, exit here */
if (pci_read_config16(device, PCI_VENDOR_ID) == 0xFFFF)
return current;
printk(BIOS_DEBUG, "ACPI: * IGD OpRegion\n");
opregion = (igd_opregion_t *)current;
if (intel_gma_init_igd_opregion(opregion) != CB_SUCCESS)
return current;
if (gnvs)
gnvs->aslb = (u32)(uintptr_t)opregion;
update_igd_opregion(opregion);
current += sizeof(igd_opregion_t);
current = acpi_align_current(current);
printk(BIOS_DEBUG, "current = %lx\n", current);
return current;
}
const struct i915_gpu_controller_info *
intel_igd_get_controller_info(struct device *device)
{
struct soc_intel_skylake_config *chip = device->chip_info;
return &chip->gfx;
}
|
