1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
|
/*
* Copyright (C) 2006 Uwe Hermann <uwe@hermann-uwe.de>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
*/
#include <arch/romcc_io.h>
#include "it8705f.h"
/* The base address is 0x2e or 0x4e, depending on config bytes. */
#define SIO_BASE 0x2e
#define SIO_INDEX SIO_BASE
#define SIO_DATA SIO_BASE+1
/* Global Configuration Registers. */
#define IT8705F_CONFIG_REG_CC 0x02 /* Configure Control (write-only). */
#define IT8705F_CONFIG_REG_LDN 0x07 /* Logical Device Number. */
#define IT8705F_CONFIG_REG_CONFIGSEL 0x22 /* Configuration Select. */
/* WTF? 0x23 and 0x24 are swapped here (when compared to other IT87xx). */
#define IT8705F_CONFIG_REG_CLOCKSEL 0x24 /* Clock Selection. */
#define IT8705F_CONFIG_REG_SWSUSP 0x23 /* Software Suspend, Flash I/F. */
#define IT8705F_CONFIGURATION_PORT 0x2e /* Write-only. */
/* The content of IT8705F_CONFIG_REG_LDN (index 0x07) must be set to the
* LDN the register belongs to, before you can access the register. */
static void it8705f_sio_write(uint8_t ldn, uint8_t index, uint8_t value)
{
outb(IT8705F_CONFIG_REG_LDN, SIO_BASE);
outb(ldn, SIO_DATA);
outb(index, SIO_BASE);
outb(value, SIO_DATA);
}
/* Enable the peripheral devices on the IT8705F Super IO chip. */
static void it8705f_enable_serial(device_t dev, unsigned iobase)
{
/* (1) Enter the configuration state (MB PnP mode). */
/* Perform MB PnP setup to put the SIO chip at 0x2e. */
/* Base address 0x2e: 0x87 0x01 0x55 0x55. */
/* Base address 0x4e: 0x87 0x01 0x55 0xaa. */
outb(0x87, IT8705F_CONFIGURATION_PORT);
outb(0x01, IT8705F_CONFIGURATION_PORT);
outb(0x55, IT8705F_CONFIGURATION_PORT);
outb(0x55, IT8705F_CONFIGURATION_PORT);
/* (2) Modify the data of configuration registers. */
/* Select the chip to configure (if there's more than one).
* Set bit 7 to select JP3=1, clear bit 7 to select JP3=0.
* If this register is not written, both chips are configured. */
/* it8705f_sio_write(0x00, IT8705F_CONFIG_REG_CONFIGSEL, 0x00); */
/* Enable all devices. */
it8705f_sio_write(IT8705F_FDC, 0x30, 0x1); /* Floppy */
it8705f_sio_write(IT8705F_SP1, 0x30, 0x1); /* Serial port 1 */
it8705f_sio_write(IT8705F_SP2, 0x30, 0x1); /* Serial port 2 */
it8705f_sio_write(IT8705F_PP, 0x30, 0x1); /* Parallel port */
it8705f_sio_write(IT8705F_EC, 0x30, 0x1); /* Environment controller */
/* GPIO */
it8705f_sio_write(IT8705F_GAME, 0x30, 0x1); /* GAME port */
it8705f_sio_write(IT8705F_IR, 0x30, 0x1); /* Consumer IR */
it8705f_sio_write(IT8705F_MIDI, 0x30, 0x1); /* MIDI port */
/* Select 24MHz/48MHz CLKIN (set/clear bit 0). TODO: Needed? */
/* it8705f_sio_write(0x00, IT8705F_CONFIG_REG_CLOCKSEL, 0x00); */
/* Clear software suspend mode (clear bit 0). TODO: Needed? */
/* it8705f_sio_write(0x00, IT8705F_CONFIG_REG_SWSUSP, 0x00); */
/* (3) Exit the configuration state (MB PnP mode). */
it8705f_sio_write(0x00, IT8705F_CONFIG_REG_CC, 0x02);
}
|