| Age | Commit message (Collapse) | Author |
|---|
|
Change-Id: I183b9942929c873c3272ce6d1abd4ebc472c7132
Reviewed-by: Andreas Sandberg <andreas.sandberg@arm.com>
|
|
Although the cache models support wider accesses, the ISA descriptions
assume that (for the most part) memory operands are integer types,
which makes it difficult to define instructions that do memory accesses
larger than 64 bits.
This patch adds some generic support for memory operands that are arrays
of uint64_t, and specifically a 'u2qw' operand type for x86 that is an
array of 2 uint64_ts (128 bits). This support is unused at this point,
but will be needed shortly for cmpxchg16b. Ideally the 128-bit SSE
memory accesses will also be rewritten to use this support.
Support for 128-bit accesses could also have been added using the gcc
__int128_t extension, which would have been less disruptive. However,
although clang also supports __int128_t, it's still non-standard.
Also, more importantly, this approach creates a path to defining
256- and 512-byte operands as well, which will be useful for eventual
AVX support.
|
|
For historical reasons, the ExecContext interface had a single
function, readMem(), that did two different things depending on
whether the ExecContext supported atomic memory mode (i.e.,
AtomicSimpleCPU) or timing memory mode (all the other models).
In the former case, it actually performed a memory read; in the
latter case, it merely initiated a read access, and the read
completion did not happen until later when a response packet
arrived from the memory system.
This led to some confusing things, including timing accesses
being required to provide a pointer for the return data even
though that pointer was only used in atomic mode.
This patch splits this interface, adding a new initiateMemRead()
function to the ExecContext interface to replace the timing-mode
use of readMem().
For consistency and clarity, the readMemTiming() helper function
in the ISA definitions is renamed to initiateMemRead() as well.
For x86, where the access size is passed in explicitly, we can
also get rid of the data parameter at this level. For other ISAs,
where the access size is determined from the type of the data
parameter, we have to keep the parameter for that purpose.
|
|
The readMemAtomic/writeMemAtomic helper functions were calling
readMemTiming/writeMemTiming respectively. This is functionally
correct, since the *Timing functions are doing the same access
initiation operation as the *Atomic functions (just that the
*Atomic versions also complete the access in line). It also
provides for some (very minimal) code reuse. Unfortunately,
it's potentially pretty confusing, since it makes it look like
the atomic accesses are somehow being converted to timing
accesses. It also gets in the way of specializing the timing
interface (as will be done in a future patch).
|
|
This patch takes quite a large step in transitioning from the ad-hoc
RefCountingPtr to the c++11 shared_ptr by adopting its use for all
Faults. There are no changes in behaviour, and the code modifications
are mostly just replacing "new" with "make_shared".
|
|
readBytes and writeBytes had the word "bytes" in their names because they
accessed blobs of bytes. This distinguished them from the read and write
functions which handled higher level data types. Because those functions don't
exist any more, this change renames readBytes and writeBytes to more general
names, readMem and writeMem, which reflect the fact that they are how you read
and write memory. This also makes their names more consistent with the
register reading/writing functions, although those are still read and set for
some reason.
|
|
|
