diff options
Diffstat (limited to 'include/configs/cm_t54.h')
| -rw-r--r-- | include/configs/cm_t54.h | 126 |
1 files changed, 126 insertions, 0 deletions
diff --git a/include/configs/cm_t54.h b/include/configs/cm_t54.h new file mode 100644 index 0000000..2387f86 --- /dev/null +++ b/include/configs/cm_t54.h @@ -0,0 +1,126 @@ +/* SPDX-License-Identifier: GPL-2.0+ */ +/* + * Config file for Compulab CM-T54 board + * + * Copyright (C) 2014, Compulab Ltd - http://compulab.co.il/ + * + * Author: Dmitry Lifshitz <lifshitz@compulab.co.il> + */ + +#ifndef __CONFIG_CM_T54_H +#define __CONFIG_CM_T54_H + +#define CONFIG_CM_T54 +#define CONFIG_DRAM_2G + +#define PARTS_DEFAULT + +#include <configs/ti_omap5_common.h> + +/* EEPROM related defines */ +#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 +#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 +#define CONFIG_SYS_I2C_EEPROM_BUS 0 + +/* Enable SD/MMC CD and WP GPIOs */ +#define OMAP_HSMMC_USE_GPIO + +/* UART setup */ +#define CONFIG_SYS_NS16550_COM4 UART4_BASE + +/* MMC ENV related defines */ +#undef CONFIG_ENV_OFFSET +#undef CONFIG_ENV_SIZE + +#define CONFIG_SYS_MMC_ENV_DEV 1 /* SLOT2: eMMC(1) */ +#define CONFIG_SYS_MMC_ENV_PART 0 +#define CONFIG_ENV_OFFSET 0xc0000 /* (in bytes) 768 KB */ +#define CONFIG_ENV_SIZE (16 << 10) /* 16 KB */ +#define CONFIG_ENV_OFFSET_REDUND (CONFIG_ENV_OFFSET + CONFIG_ENV_SIZE) +#define CONFIG_SYS_REDUNDAND_ENVIRONMENT + +/* Enhance our eMMC support / experience. */ +#define CONFIG_HSMMC2_8BIT + +/* SATA Boot related defines */ +#define CONFIG_SPL_SATA_BOOT_DEVICE 0 +#define CONFIG_SYS_SATA_FAT_BOOT_PARTITION 1 + +#define CONFIG_SCSI_AHCI_PLAT +#define CONFIG_SYS_SCSI_MAX_SCSI_ID 1 +#define CONFIG_SYS_SCSI_MAX_LUN 1 +#define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \ + CONFIG_SYS_SCSI_MAX_LUN) +/* USB UHH support options */ +#define CONFIG_EHCI_HCD_INIT_AFTER_RESET + +#define CONFIG_OMAP_EHCI_PHY2_RESET_GPIO 76 /* HSIC2 HUB #RESET */ +#define CONFIG_OMAP_EHCI_PHY3_RESET_GPIO 83 /* HSIC3 ETH #RESET */ + +/* Enabled commands */ + +/* EEPROM */ +#define CONFIG_ENV_EEPROM_IS_ON_I2C +#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 +#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 4 +#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5 +#define CONFIG_SYS_EEPROM_SIZE 256 + +/* USB Networking options */ + +/* + * Miscellaneous configurable options + */ +#undef CONFIG_SYS_AUTOLOAD +#undef CONFIG_EXTRA_ENV_SETTINGS +#undef CONFIG_BOOTCOMMAND + +#define CONFIG_SYS_AUTOLOAD "no" + +#define CONFIG_EXTRA_ENV_SETTINGS \ + DEFAULT_LINUX_BOOT_ENV \ + "baudrate=115200\0" \ + "bootdelay=3\0" \ + "autoload=no\0" \ + "bootscr=bootscr.img\0" \ + "fdtfile=omap5-sbc-t54.dtb\0" \ + "kernel=zImage-cm-t54\0" \ + "ramdisk=ramdisk-cm-t54.img\0" \ + "console=ttyO3\0" \ + "ramdisksize=16384\0" \ + "mmcdev=0\0" \ + "mmcroot=/dev/mmcblk1p2\0" \ + "mmcargs=setenv bootargs console=${console} " \ + "root=${mmcroot} rw rootwait\0" \ + "ramroot=/dev/ram0\0" \ + "ramargs=setenv bootargs console=${console} " \ + "root=${ramroot} ramdisk_size=${ramdisksize} rw\0" \ + "mmcloadkernel=load mmc ${mmcdev} ${loadaddr} ${kernel}\0" \ + "mmcloadfdt=load mmc ${mmcdev} ${fdtaddr} ${fdtfile}\0" \ + "mmcloadramdisk=load mmc ${mmcdev} ${rdaddr} ${ramdisk}\0" \ + "mmcloadbootscript=load mmc ${mmcdev} ${loadaddr} ${bootsrc}\0" \ + "mmcbootscript=echo Running bootscript from mmc${mmcdev}...; " \ + "source ${loadaddr}\0" \ + "mmcbootlinux=echo Booting from mmc${mmcdev} ...; " \ + "bootz ${loadaddr} ${rdaddr} ${fdtaddr}\0" \ + "mmcboot=if mmc dev ${mmcdev} && mmc rescan; then " \ + "if run mmcloadbootscript; " \ + "then run mmcbootscript; " \ + "fi; " \ + "if run mmcloadkernel; then " \ + "if run mmcloadfdt; then " \ + "if run mmcloadramdisk; then " \ + "run ramargs; " \ + "run mmcbootlinux; " \ + "fi; " \ + "run mmcargs; " \ + "setenv rdaddr - ; " \ + "run mmcbootlinux; " \ + "fi; " \ + "fi; " \ + "fi;\0" + +#define CONFIG_BOOTCOMMAND \ + "bootcmd=run mmcboot || setenv mmcdev 1; setenv mmcroot /dev/mmcblk0p2; run mmcboot;" + +#endif /* __CONFIG_CM_T54_H */ |